Image-based Modeling and Stress Analysis by Homogenization Method for Porous  Alumina Ceramics

Yasushi IKEDA; Yasuo NAGANO; Hiroshi KAWAMOTO; Naoki TAKANO

doi:10.14852/jcersjsuppl.112.0.S1052.0

Journal of the Ceramic Society of Japan, Supplement 112-1, PacRim5 Special Issue

セッションID: 14

DOI https://doi.org/10.14852/jcersjsuppl.112.0.S1052.0

会議情報

主催: The Ceramic Society of Japan

共催: Iketani Science and Technology Foundation, International Ceramic Federation, Commemorative Organization for the Japan World Exposition '70, The American Ceramic Society, The Australasian Ceramic Society, The Chinese Ceramic Society, The Korean Ceramic Society, Joint Research Consortium of Synergy Ceramics/Fine Ceramics Research Association, Nanotechnology Researchers Network Center of Japan, The Special Coordination Funds for Promoting Science and Technology, Japan National Tourist Organization, Aichi Prefectural Government, CASIO SCIENCE PROMOTION FOUNDATION, DAIKO FOUNDATION, Nagoya Convention and Visitors Bureau, The Asahi Glass Foundation, The Kao Foundation For Arts And Sciences, The Murata Science Foundation, The Ogasawara Foundation for the Promotion of Science & Engineering, ASAHI GLASS CO., LTD. Research Center, CENTRAL GLASS CO., LTD., ELECTRIC GLASS INDUSTRY ASSOCIATION OF JAPAN (EGAJ), Hattori Company, Ltd., Hitachi Research Laboratory, Hitachi, Ltd., HOYA CORPORATION, INAX Corporation, ITOCHU CERATECH CORP., Japan Cement Association, KYOCERA Corporation, KYUSHU REFRACTORIES CO., LTD., MINO CERAMIC CO., LTD., Murata Manufacturing Co., Ltd., NGK INSULATORS LTD., NGK SPARK PLUG CO., LTD., NICHIAS Corporation, NIKKO COMPANY, Nippon Electric Glass Co., Ltd., Nippon Sheet Glass Co., Ltd., NORITAKE CO., LIMITED, Tokuyama Corporation, TOTO LTD.

Papers

Image-based Modeling and Stress Analysis by Homogenization Method for Porous Alumina Ceramics

Yasushi IKEDA, Yasuo NAGANO, Hiroshi KAWAMOTO, Naoki TAKANO

著者情報

キーワード: Porous ceramics, Stress analysis, Homogenization method, Image-based modeling, X-ray CT, FEM simulation

会議録・要旨集フリー

詳細

抄録

The 3-D image modeling of the porous alumina was obtained by X-ray CT, and microscopic volume elements were obtained from it. Porous alumina including spherical pores 60 μm and 20 μm in diameter with porosities 7.05% and 1.76% were studied by homogenization method, which calculated homogenized elastic constants for the microscopic volumes. These constants were applied to simulate 4-point bending tests and to analyze macroscopic stress distributions coupled with FEM calculation. Microscopic stress distributions were analyzed using the FEM result. The maximum microscopic stress concentration near a spherical pore were about 2 times higher than the average stress one.

責任著者(Corresponding author)

J-STAGEへの登録はこちら（無料）