溶融めっき浴内における地金の拡散特性に関するコールドモデル実験

抄録

The dispersion of melted ingots in a continuous hot dip plating bath was investigated using a transparent cold model vessel with a reduced scale of one-tenth. The used tracers were CaCO₃ particles with a mean diameter of 1.0 μm and 5.0 mass%KCl aqueous solution. The dispersion of the CaCO₃ particles in the bath was observed by eye inspection. The mixing time and the local concentration of the two kinds of tracers were measured with an electrical conductivity sensor and a Laser beam sensor. The dispersion of the CaCO₃ particles was mainly controlled by the main stream of liquid caused by the motion of the belt in the bath. The mixing time and the local concentration of the tracer were dependent on the measurement position. The mixing time was shortest when the tracer was introduced in the exit region, i.e., the belt out-going region. This fact suggests that the mixing time in the real bath is shortest by introducing ingots into the exit region.