粉体および粉末冶金
Online ISSN : 1880-9014
Print ISSN : 0532-8799
ISSN-L : 0532-8799
研究論文
液相-固相反応法で合成したMg2Si 系化合物の焼結性と熱電特性に及ぼすMg仕込量とB添加量の影響
富永 彰伊藤 孝至
著者情報
ジャーナル オープンアクセス

2013 年 60 巻 8 号 p. 354-359

詳細
抄録
Dimagnesium silicide (Mg2Si) is a promising n – type thermoelectric compound suitable for thermoelectric power generation using waste heat of intermediate temperature range (600 − 900 K). However, there are two problems in making the Mg2Si compound. One is difficulty in synthesizing the compound due to ease of Mg evaporation in fusion, resulting in existence of non-reacting Si. Another is difficulty in sintering the synthesized powder. In order to overcome the two problems, we synthesized the Mg2Si compound on Mg – rich state by the liquid-solid phase reaction and sintered the synthesized powder by the pulse discharge sintering (PDS). The influences of Mg/Si ratio and B addition on the sinterability and the thermoelectric properties of the synthesized Mg2Si compounds were investigated. The sinterability of the synthesized Mg2Si compounds were improved by the increase of Mg amount. And, electrical resistivities of sintered samples were decreased by B addition. Therefore, thermoelectric properties were strongly affected by both Mg/Si ratio and B addition. The sample synthesized with feed amount of Mg of 67.00 at% and additive amount of B of 1.0 at% had the maximum dimensionless figure of merit of about 0.39 at 773 K.
著者関連情報
© 2013一般社団法人粉体粉末冶金協会

本論文はCC BY-NC-NDライセンスによって許諾されています.ライセンスの内容を知りたい方は,https://creativecommons.org/licenses/by-nc-nd/4.0/deed.jaでご確認ください.
https://creativecommons.org/licenses/by-nc-nd/4.0/deed.ja
前の記事 次の記事
feedback
Top