2016 Volume 65 Issue 7 Pages 577-592
In this work, novel hybrid-type corynomycolic acids [hybrid-OH and hybrid-COOH, with semifluoroalkyl groups (Rf-(CH2)n-: Rf = C4F9, n = 6 and Rf = C6F13, n = 3) located on the carbon atoms attached to the hydroxyl and carboxylic acid groups (C-OH and C-COOH), respectively] were successfully synthesized. The behaviors and formation of hybrid corynomycolic acid monolayers at the air-water interface were investigated by surface tension and surface pressure-area (π-A) measurements to clarify the effects of the Rf chain length, position of the semifluoroalkyl group, and surfactant molecule stereochemistry. Compared to dialkyl corynomycolic acid, both the critical micelle concentration (CMC) and the surface tension at the CMC (γCMC) of hybrid corynomycolic acids were reduced by the presence of the Rf group. With respect to the surface tension versus log concentration (γ vs. log C) isotherms, all syn-isomers of the hybrid-OH and hybrid-COOH acids showed two break points, while the anti-isomers showed only one break point. These different isotherms can be explained in terms of the steric repulsion between the two hydrophilic groups (OH and COO–), which depend on the stereochemistry of the surfactant. No effect of the location of the semifluoroalkyl group was observed. With respect to the formation of a monolayer film, four parameters—the lift-off area (AL), zero-pressure molecular area (A0), maximum of the Gibbs elastic modulus [EG (max)], and monolayer collapse pressure (πc)—were measured. Both AL and A0 of all hybrid corynomycolic acids were larger than the corresponding dialkyl acids due to the bulky and rigid Rf groups. Interestingly, syn- and anti-hybrids had almost identical isotherms on compression, although the values of πc of anti-hybrids were higher than those of syn-isomers. In addition, the values of EG (max) of hybrid-COOHs were slightly larger than those of the corresponding hybrid-OHs. Using the nascent soap method (agent-in-oil method), we found that anti-F4C6-OH (a hybrid corynomycolic acid) is a promising emulsifier for a ternary system comprising octane, water, and perfluoropolyether oil.
