Punching Holes in Sheet Glass Under High Pressure : Vibration, Control Engineering, Engineering for Industry
1987 年 30 巻 269 号 p. 1833-1839
詳細
1987 年 30 巻 269 号 p. 1833-1839
Many kinds of recently developed materials are very hard and brittle, and it is very difficult and expensive to process them. Thus, it is necessary to develop an easier and more economical method to process these materials. As an example, punching holes in sheet glass was studied. Because punching holes in sheet glass by ordinary methods is impossible, we present a method for punching holes in sheet glass under static high pressure. This research confirmed that it is possible to punch holes in sheet glass, and clarified the conditions needed to obtain good holes without defects.
JSME International Journal Series C Mechanical Systems, Machine Elements and Manufacturing
JSME International Journal Series B Fluids and Thermal Engineering
JSME International Journal Series A Solid Mechanics and Material Engineering
JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry
JSME international journal. Ser. A, Mechanics and material engineering
JSME international journal. Ser. 1, Solid mechanics, strength of materials
