Abstract
This study is aimed at exploring possibilities to improve the injectability of wood powder and the mechanical properties of the injected product while keeping the amount of binder to its minimum. In the preliminary experiment, injection moulding of Japanese cedar wood powder was conducted. The effects of binder content (PE; pellet-size) and nozzle temperature on the tensile strength and strain at break of the product were investigated. Results showed that under such conditions, injection moulding of wood powder only was not possible due to insufficient fluidity. Increasing the binder content and the nozzle temperature resulted to a decrease in the maximum injection pressure and improvement in the fluidity of the powder. Using the same PE content, increasing the temperature resulted to an increase in tensile strength of the injected product. However, the strain at break was decreased. Moreover, at PE content below 50%, the strength and strain decreased considerably.
