Dynamics & Design Conference
Online ISSN : 2424-2993
会議情報

薄肉長方形板のエンドミル加工時に発生するびびり振動
(びびり振動と固有振動との関係)
盛岡 盾哉栗田 裕上田 久川田 昌宏原田 岳志眞喜志 康平
著者情報
会議録・要旨集 認証あり

p. 118-

詳細
抄録

This paper describes chatter vibration generated in a thin rectangular plate at end milling. When end milling the thin rectangular plate, the end mill does not vibrate, and chatter vibration is generated in which the rectangular plate deforms in the out-of-plane direction. The frequency of chatter vibration generated is low near the edge of the rectangular plate and high near the center of the rectangular plate. The vibration mode of chatter vibration when the tool position is near the edge of the rectangular plate is the antiphase mode with the tool position as a node. The vibration mode of chatter vibration when the tool position is near the center of the rectangular plate is the in-phase mode in which both ends of the rectangular plate vibrate in the same phase. The frequency and vibration mode of this chatter vibration agree with the

著者関連情報
© 2020 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top