Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Online ISSN : 2424-3086
ISSN-L : 2424-3086
2003
会議情報
225 Development of resin-bonded grinding wheel by stereolithography
Takeshi TANAKAKenichi OKUSHIMA
著者情報
会議録・要旨集 フリー

p. 339-344

詳細
抄録
In the context of present-day industries needs, such as improvement of resin-bonded grinding wheels, the authors propose a promising method for fabricating the resin-bonded grinding wheels (the authors named "Resin-Piled wheel : RP wheel") by stereolithography. In this proposal, the photohardenable resin/grain mixture is used to fabricate the resin-bonded grinding wheel. This paper describes the results of fundamental study. First, we revealed the optimum stereolithography conditions by curing tests. Subsequently, we developed the special experimental apparatuses (SLA and RCA), and carried out the fabrication of the 1A1-type wheels and the stick type wheels using these SLA and RCA. Furthemore, the grinding tests were performed. The main superiorities of RP wheel compared to the commercial wheels are as follows; (1) drastically decreasing of fabrication time within 10 min, (2) few coagulation of abrasive grains, (3) lower wheel wear in grinding with smaller surface roughness.
著者関連情報
© 2003 The Japan Society of Mechanical Engineers
前の記事 次の記事
feedback
Top