Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Online ISSN : 2424-3086
ISSN-L : 2424-3086
会議情報
The Influence Of Cutting Tool Rake Angle On Cutting Forces When Machining Aluminium Alloys(Advanced machining technology)
Sekmen MustafaGunay MustafaIbrahim CiftciIhsan KorkutUlvi SEKER
著者情報
会議録・要旨集 フリー

p. 173-176

詳細
抄録
In this study, experimental investigation of the effect of cutting tool rake angle during machining of AA 2011 and AA 7075 aluminium alloys was carried out. For this purpose, a previously designed and manufactured dynamometer incorporating load cells was used to measure the cutting forces during turning. This system enabled the tool holder to rotate so that the cutting tool's rake angle could be adjusted. The machining tests were conducted at six different rake angles, five different cutting speeds while feed rate and depth of cut were kept constant. During the tests, primary cutting force (F_c) and feed force (F_a) components were measured and recorded on a personal computer (PC). Theoretical cutting force values were also determined using Kienzle approach. The results showed that cutting forces decreased with increasing rake angle and increasing cutting speed for the both alloys.
著者関連情報
© 2005 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top