Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Online ISSN : 2424-3086
ISSN-L : 2424-3086
2007.4
セッションID: 8D427
会議情報

Design of Screw-Surface Finish Using Burnishing Assistance Following Electrochemical Finishing
P.S. Pa
著者情報
会議録・要旨集 フリー

詳細
抄録

An effective and low-cost finish processes through burnishing assistance following electrochemical finishing after screw machining offers a fast improvement for the surface roughness of the screw-surface is a new application in the screw finishing process. The burnishing-tool uses ceramic material connected with the electrode and moves, following the electrode, to burnish the workpiece. The results show that the use of a higher rotational speed for the electrode and burnishing-tool is advantageous to the finish. Pulsed direct current can slightly improve the finish effect. A partial form with a thinner heavy section performs the best finish effect in the current investigation.

著者関連情報
© 2007 The Japan Society of Mechanical Engineers
前の記事 次の記事
feedback
Top