Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Online ISSN : 2424-3086
ISSN-L : 2424-3086
セッションID: 527
会議情報
0527 A Method for Identification of Control Parameters of NC Machine Tool and its Utilization for High-Speed Machining and Accurate Machining Time Estimation
Yuki YamamotoHideki AoyamaNoriaki Sano
著者情報
会議録・要旨集 フリー

詳細
抄録
When cutting freeform surface using NC machine tools, two problems occurred. The first arises because the actual feedrate deviates from the command feedrate. The second is the decreasing surface quality due to the large acceleration and deceleration of the control axes. The main cause is the fact that the toolpath of the NC program does not consider control characters .In this paper, an automatic identification method of a sampling time and a generation method of an NC program that considers sampling time are proposed. In addition, a system is proposed to estimate the machining time. The effectiveness of the proposed methods is confirmed by experiments.
著者関連情報
© 2015 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top