年次大会
Online ISSN : 2424-2667
ISSN-L : 2424-2667
セッションID: G060024
会議情報
G060024 ヒートパイプによる成形金型の加熱・冷却システムの研究([G06002]熱工学部門一般セッション(2):ヒートパイプ・熱サイホン)
中城 啓太齊藤 卓志川口 達也佐藤 勲
著者情報
会議録・要旨集 フリー

詳細
抄録
In this study, a heat pipe system was installed into the mold used in the polymer processing to enhance the heating and cooling rate of the mold as well as to reduce the required thermal energy for the temperature control of the mold, and the characteristics of the system were experimentally investigated. The result showed that the maximum heat flux value of 18 kW/m2 was achieved at the individual operation. By using the system, thermal energy can be transported between a pair of the molds in the sense of thermal district. The result showed that the maximum heat flux value of 8.0 kW/m2 was realized under the thermal energy exchange. And it was expected that the energy consumption to control the mold temperature would be reduced.
著者関連情報
© 2011 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top