生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会
Online ISSN : 2424-3094
会議情報
225 電着ダイヤモンドワイヤ工具の高速製造法の開発 : 砥粒共析量に関する検討
千葉 康雅谷 泰弘榎本 俊之
著者情報
会議録・要旨集 フリー

p. 217-218

詳細
抄録
Fixed-abrasive multi-wire sawing process has been introduced by using a resinoind diamond wire tool or an electroplated diamond wire tool. Electroplated diamond wire tools have higher wear resistance, but the production cost is very high because the time required for electroplating in the manufacturing process is too long. Consequently, the tools cannot be applied to practical use. Then, ultra high-speed electroplating using a felt brush is proposed to adopt for manufacturing the tools in order to reduce the production cost. In this study, the effect of the electroplating factors, such as conductivity of abrasive, surfactant and shape of brush, on the amount of electrodeposited diamond grains was discussed. As a result, it was enable to change the amount and make the wire tool diameter uniform.
著者関連情報
© 2002 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top