主催: 一般社団法人 日本機械学会
会議名: 第12回生産加工・工作機械部門講演会
開催日: 2018/10/13 - 2018/10/14
Machinability of Inconel 718 is remarkably poor, so cutting is carried out in the low speed region at the production site. On the other hand, in recent years, high-efficiency cutting by using a ceramic end mill has been put to practical use in rough machining, but there are some problems such as welding on tools, short tool life, poor finished surface. In this study, the influence of gas blow supply to cutting point on welding and tool life in high-speed cutting of Inconel 718 was investigated.