ロボティクス・メカトロニクス講演会講演概要集
Online ISSN : 2424-3124
セッションID: 2A1-Q07
会議情報

熱溶融積層方式による樹脂構造材を用いた四足歩行ロボットTITAN-E1の開発
角田 柊平難波江 裕之鈴森 康一*遠藤 玄
著者情報
会議録・要旨集 認証あり

詳細
抄録

In recent years, the use of 3D printed plastic parts has been attracting attention. However, due to their inferior dimension accuracy, stiffness and strength, there are few examples of using them as structural parts for robots that are subjected to loads. In this study, we developed a quadruped robot, TITAN-E1, in order to verify the applicability of plastic parts made by fused deposition modeling 3D printers to robot structural parts. As a result, it was found that the 3D printed plastic parts had the sufficient dimensional accuracy and the stiffness and strength required for stable static walking. Therefore, the applicability of the 3D printed plastic parts to the structural parts of the quadruped robot was confirmed.

著者関連情報
© 2022 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top