公開研究会・講演会技術と社会の関連を巡って : 技術史から経営戦略まで : 講演論文集
Online ISSN : 2432-9487
セッションID: 103
会議情報

低温度差模型スターリングエンジンを共同で手加工するためのプロジェクトマネジメント
*加藤 義隆
著者情報
会議録・要旨集 認証あり

詳細
抄録

First grade students of Mechanical Engineering Program could not make low temperature differential Stirling engine within 270 minutes as a first year seminar. The 270 minutes means three 90-minute works. The prototype of the low temperature differential Stirling engine had been made by one person within 7 hours. The fail by the students may be caused by the papers showing the shapes of parts made of poly-vinyl chloride. The paper was designed for the paerson who made low temperature differential Stirling engine alone. Therefore, the pattern papers should be improved to promote a division of work. The project for 12 students to make a low temperature differential Stirling engine is planned. When the 12 students can use 3 hand drills, three 1.0mm-drill-bits, three 3.0mm-drill-bits, 3 countersink-drills, 3 scissors, 3 long nose pliers, 1 cutter knife, and 1 hacksaw, the planned project suggests the low temperature differential Stirling engine is made within 180miniutes. This 180 minutes means two 90-minute works.

著者関連情報
© 2024 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top