抄録
Investigation was carried out on the influence of mechanical properties on the intensity of axial residual stress after cold drawing of metallic bars. Yield stress, Young's modulus, and work-hardening ratio were chosen as indications of mechanical properties, and quantitative influence was examined numerically on an ordinary cold drawing. After examining the quantitative influence of mechanical properties on the axial residual stress after drawing, further numerical experiments were carried out on the skin-pass effect in reducing the intensity of axial residual stress distribution, which the authors presented a result in the previous study by using S45C steel bars. In order to clarify the validity of the numerical analysis, various materials of different mechanical properties were selected, and cold drawing experiments were carried out in a laboratory to check the validity of the numerical results. The materials selected were (1) high-carbon steel, (2) medium carbon steel, (3) copper, and (4) aluminum. The residual stress was measured by Sachs method, and good agreement was obtained between the calculated and measured results in any case. It was found that the axial residual stress distribution is most sensitive to the work-hardening ratio, and an optimum skin-pass drawing condition was presented by quantitatively examining the effect of skin-pass in reducing the axial residual distribution.
