Additive manufacturing（AM）technologies have attracted much attention because it enables us to build 3D parts with complicated geometry easily and control material properties significantly via the control of microstructures. In the powder- bed fusion（PBF）type AM process, 3D parts are fabricated by repeating a process of melting and solidifying metal powders by laser or electron beams. In general, the solidification microstructures can be predicted from solidification conditions defined by the combination of temperature gradient G and solidification rate R on the basis of columnar-equiaxed transition（CET）theory proposed by Hunt [Mater. Sci. Eng. 65, 75（1984）]. However, it is unclear whether the CET theory can be applied to the PBF type AM process because of the high G and R, even for general 316L stainless steel. In this study, to reveal relationships between microstructures and solidification conditions, we have analyzed solidification microstructures of 316L steel induced by electron- beam irradiation and evaluated solidification conditions at the solid/liquid interface using a computational thermal-fluid dynamics （CtFD）method. It was found that equiaxed grains were often formed under high G conditions contrary to the CET theory. CtFD simulation revealed that there is a fluid flow up to a velocity of about 400 mm s -1 , and suggested that equiaxed grains are formed owing to the effect of fragmentations and migrations of dendrites.
