N2M/C 無人化への取り組み
リール～ワインダー間の親巻・スプールの自動搬送
2002 年 56 巻 1 号 p. 96-100
詳細
2002 年 56 巻 1 号 p. 96-100
N2-machine for newsprint was started in Feb., 1998, at Yatsushiro mill. This machine has a lot of newest equipments, using the highest technologies. The jumbo rolls and spools handling system is one of them, and introduced into N2-machine for reasons of automatically transfer.
This system has two works, the jumbo rolls are transfered by the lower guide rails from reel to rewinder, and spools are transfered by the upper guide rails from rewinder to reel. In No. 2 winder, the jumbo rolls and spools handling is carried out by Jumbo Roll Carriage which has two stages.
This system has some accessory devices as follows.
(1) Device for putting the rest paper on the spool into the pulper.
(2) Jumbo roll paper end tape applicator.
(3) Auto splice device between the jumbo rolls.
Therefore automatically transfer is realized today.
This paper describes about this handling system outlines and operating circumstances from startup
