X形熱線プローブを用いたフライングホットワイヤ法による速度の3方向成分の同時計測 : 第2報,熱線センサの校正方法と渦発生器下流の計測例

抄録

This paper proposes a calibration technique for a flying hot-wire method that uses with an X-array hot-wire probe. The flying hot-wire system moves the hot-wire probe in the spanwise Z-direction of the flow field. The calibration of yaw and pitch angle sensitivities of the probe is of utmost importance to this system. After careful calibration, the system is applied to a three-dimensional flow to obtain three components of the mean velocity and six components of the Reynolds stress. The mean velocities and the Reynolds shear stresses downstream of a pair of vortex generators embedded in a two-dimensional boundary layer show the same profiles as those obtained with an ordinary X-array hot-wire probe. In one traverse, the flying hot-wire system can measure 60 points of six components of the Reynolds stress with good accuracy.