ボールエンドミルによる傾斜最適送りの実現
1990 年 56 巻 521 号 p. 189-194
詳細
1990 年 56 巻 521 号 p. 189-194
An attempt was made to cutting by rising gradient cutting, falling gradient cutting in a inclined plane with ball end mill. It was observed that there was optimized feed in each inclined plane. So, an attempt was made to cutting by gradient optimized feed and continuous feed. As a result, it was found that the gradient optimized feed was successful not only in improving tool life, but also in achieving better finished surface roughness.
