2005 Volume 46 Issue 5 Pages 935-943
The solidification microstructure and crystal orientation have been investigated for solar cell grade high purity multicrystal silicon through a unidirectional solidification technique. The mechanism of the twin growth on a reentrant corner has been also discussed. A columnar structure is observed at solidification velocities of 1.25–30 μm/s and positive temperature gradient of 20 K/cm in the rod-like silicon specimens in an electric resistance furnace. In the solidification velocity range of 1.25–2.5 μm/s, the grain size enlarges as solidification progresses. Furthermore, large columnar grains contain many twin boundaries. However, the average grain size decreases as the solidification velocity increases and above the critical velocity around 40 μm/s, equiaxed structure appears at the central part of specimens. Therefore, molten silicon must be solidified at the velocity below 2.5 μm/s where twins are always introduced into grains to obtain large columnar crystal grains. The undercooling for directional growth is less than 4 K in the solidification velocity range of 1.25–30 μm/s. A model of two-dimensional nucleation on the reentrant corner was established, and the critical nucleus could be estimated to be 70 to 80% of the radius of the general two-dimensional nucleus. The nucleation undercooling on the surface containing twins also decreased to 70% of the general undercooling. The reduction of the critical radius and undercooling on the reentrant corner could eventually influence on the priority growth direction and the enlargement of the grain size.
