Online ISSN : 1347-5320
Print ISSN : 1345-9678
ISSN-L : 1345-9678
Influence of Silicon Content, Strain Rate and Temperature on Toughness and Strength of Solid Solution Strengthened Ferritic Ductile Cast Iron
Tomohiro IkedaTakuo UmetaniNobuhiro KaiKeisaku OgiNao-Aki NodaYoshikazu Sano
Author information

2016 Volume 57 Issue 12 Pages 2132-2138


High Silicon Solid Solution Strengthened Ferritic Ductile Cast Iron possesses advantages, such as better combination of strength-elongation, higher fatigue strength, smaller section thickness sensitivity, higher machinability etc., over conventional ferrite-pearlite type ductile cast iron. However, industrial application of high Si ductile cast iron is still very limited, because of the lower Charpy impact value at room temperature. As the toughness of iron strongly depends on the strain rate as well as temperature, dynamic three-point bending tests are conducted on 3~4%Si ferritic ductile cast iron at stroke speed of 10−3~102 mm/s, and at −20~22℃. The relations of the crack initiation energy Ei, the crack propagation energy Ep, the total absorbed energy Et and the maximum bending stress σb,max to the strain rate show abrupt dropping of these characteristic values at critical strain rate, depending on silicon content and test temperature. σb,max keeps increasing with increasing strain rate $\dot{\varepsilon}$ as far as the fracture origin is ductile, it slightly decreases over $\dot{\varepsilon}_\sigma = \dot{\varepsilon}_{fD}$ where the dimple fracture completely disappears. σb,max, Et and Ei of each silicon iron is well expressed in relation to strain rate-temperature parameter R, T ln(A/$\dot{\varepsilon}$). The critical R values for Et, Ei, and σb,max (Rt, Ri and Rσ) decrease linearly with decreasing the silicon content of iron. The critical value for σb,max (Rσ) is lowest, indicating Rσ gives a wider design tolerance.

Information related to the author
© 2016 Japan Foundry Engineering Society
Previous article Next article