MATERIALS TRANSACTIONS
Online ISSN : 1347-5320
Print ISSN : 1345-9678
ISSN-L : 1345-9678
Materials Processing
Effect of Amount of Fuel for Punchability in Punchless Impact Punching by Compression Ignition
Masahito Katoh
Author information
JOURNAL FREE ACCESS FULL-TEXT HTML

2021 Volume 62 Issue 9 Pages 1386-1392

Details
Abstract

In this study, punchless punching by the compression ignition of octane and the effect of varying the amount of fuel on punchability were investigated. In the experiment, the compression in compression ignition was applied using a drop hammer. As the amount of fuel increased, the variation in the initial height of the hammer required for completing the piercing could be divided into the following four parts of the basis on the amount of fuel. In the first part, corresponding to the smallest amount of fuel, the height exhibited a large decrease. In the second part, the height decreased by a small amount. In the third part, the height increased. Finally, in the fourth part, corresponding to the largest amount of fuel, the height remained constant. The four parts were believed to be caused by differences in the chemical reactions. Moreover, the optimum amount of fuel for punching was the largest amount of fuel under the conditions of the first part.

 

This Paper was Originally Published in Japanese in J. JSTP 61 (2020) 93–98.

Content from these authors
© 2021 The Japan Society for Technology of Plasticity
Previous article Next article
feedback
Top