Abstract
A sodium-cooled fast reactor has been designed to attain a high burn-up core in commercialized fast reactor cycle systems. The sodium-cooled fast reactor adopts a wire spacer between fuel pins. The wire spacer performs functions of securing the coolant channel and mixing between subchannels. In high burn-up fuel subassemblies, the fuel pin deformation due to swelling and thermal bowing may decrease the local flow velocity in the subassembly and influence the heat removal capability. Therefore, understanding the flow field in a wire-wrapped pin bundle is important. This study performed particle image velocimetry (PIV) measurements using a wire-wrapped three-pin bundle water model to grasp the flow field in the subchannel under conditions, including the laminar to turbulent regions. The PIV results confirmed that the normalized flow velocity near the wrapping wire in the low Re number condition was relatively decreased compared to that in the high Re number condition. Meanwhile, in the region away from the wrapping wire, the maximum flow velocity was increased by decreasing the Re number. Accordingly, the PIV measurements using the three-pin bundle geometry without the wrapping wire were also conducted to understand the effect of the wrapping wires on the flow field in the subchannel. The results confirmed that the mixing due to the wrapping wire occurred, even in the laminar condition. These experimental results are useful not only for understanding the pin bundle thermal hydraulics, but also for the code validation.
