It has been well known that, in GMA welding, various welding phenomena are largely affected by the type of shielding gas used. However, up to the present time, almost no attempt has been made to utilize ‘gas composition’ for controlling welding phenomena. This study focused on this point and, thus, an investigation was made to understand how dynamic gas compositional modification affected various welding phenomena. In this study, pulsed Ar gas was injected periodically into CO2 shielding gas so that the gas composition of arc atmosphere largely modified in a very short period of time. It was found that this quick gas compositional change from CO2 to Ar led to a large decrease in arc voltage and an arc shape change from a constricted shape to a flare shape and that a molten droplet formed at the electrode tip during the CO2 period was released due to a sudden change in force balance between the molten droplet and the arc. The increase in current stimulated by the voltage drop may have assisted the metal drop detachment due to an increase in electromagnetic pinch force. If the cycle of this periodical Ar gas injection was selected to be shorter than that of repelled metal transfer in CO2 atmosphere, the repelled transfer was avoided and stable drop transfer occurred instead with far less spatter. Appropriate selections of the duration time of pulsed Ar gas injections avoided spray transfer which might cause undesirable finger-like penetration profiles. This new conceptual welding method, namely ‘Pulsed Gas MAG Welding’, required only a small amount of Ar gas to obtain the effects mentioned above.
