塑性と加工
Online ISSN : 1882-0166
Print ISSN : 0038-1586
ISSN-L : 0038-1586
論文
薄鋼板の伸びフランジ変形限界に及ぼす端面加熱とひずみ勾配の影響
飛田 隼佑 新宮 豊久山﨑 雄司飯塚 栄治玉井 良清
著者情報
ジャーナル 認証あり

2022 年 63 巻 736 号 p. 59-64

詳細
抄録

To improve the stretch flange deformation limit of ultrahigh-strength steels, a partial edge heating method was investigated. The effect of the strain gradient on the stretch flange deformation limit when a partial edge heating method was applied was investigated by the hole expansion test and FEM analysis. The stretch flange formability was improved by application of a partial edge heating method because the recovery of the shearing microstructure and the reduction of the hardness difference of microstructure. It was found that the improvement of the deformation limit strain for the strain gradient with edge heating depends on the strain gradient region. In the low strain gradient region, the improvement margin of the deformation limit strain with edge heating was small. On the other hand, in the high strain gradient region, the deformation limit strain was markedly improved compared with that without heating. It was confirmed that the strain gradient in the direction perpendicular to the maximum principal strain could be used for the prediction of the deformation limit and also the determination of the stretch flange fracture by the FEM analysis of actual parts even under edge heating conditions.

著者関連情報
© 2022 一般社団法人 日本塑性加工学会
次の記事
feedback
Top