Tetsu-to-Hagane
Online ISSN : 1883-2954
Print ISSN : 0021-1575
ISSN-L : 0021-1575
Influence of Sulphur in Heavy Oil Used for an Ingot-Reheating Furnace on Rolling
Tomoyuki MoriMasashi Kamakura
Author information
JOURNAL OPEN ACCESS

1960 Volume 46 Issue 12 Pages 1533-1538

Details
Abstract
Concerning the influences of sulphur in bunker C-oil the authers made an actual operating test with the continuous ingot-reheating furnace fired by an oil of high sulphur contents.
The results obtained were as follows:
(1) It produced more scale than by the use of an oil of low-sulphur contents.
(2) Scale on ingot surfaces became sticky.
(3) In the stronger oxidizing atmosphere of the furnace the scale on ingots was as much produced as in the oxidizing atmosphere without SO2, and did not become sticky.
These phenomena abovementioned depended no doubt upon several conditions, such as a character of reheating furnaces, draught schedule of rolling pass, etc.
But it was able to remove these phenomena from actual working by controlling the atmosphere of the furnace.
Content from these authors
© The Iron and Steel Institute of Japan

This article is licensed under a Creative Commons [Attribution-NonCommercial-NoDerivatives 4.0 International] license.
https://creativecommons.org/licenses/by-nc-nd/4.0/
Previous article Next article
feedback
Top