日本機械学会論文集
Online ISSN : 2187-9761
ISSN-L : 2187-9761

この記事には本公開記事があります。本公開記事を参照してください。
引用する場合も本公開記事を引用してください。

連続鋳造鋳型テーパ形状が凝固シェル成長に及ぼす影響の数値解析
山崎 伯公加藤 雄一郎三木 大輔中西 健雄
著者情報
ジャーナル フリー 早期公開

論文ID: 15-00054

この記事には本公開記事があります。
詳細
抄録
The growth and the deformation of the solidifying steel shell in the continuous casting process were calculated considering the taper of the mold's narrow face. The mechanism of uneven shell growth in the mold was discussed by using computational method and observations of the shell at various operating conditions such as taper and slab width. It was found that the shell at the bottom of the mold becomes uneven when the narrow face taper is insufficient. The increase of taper is effective to even shell growth, but excessive taper causes wear of mold's copper plate and breakout of the shell. To solve these problems, various kinds of mold taper design such as multiple and parabolic have been developed and adopted to molds' narrow faces. At the actual operation of continuous casting, many kinds of steel grades are cast in various casting speed and width at the same mold. So, the online change of the tilt of the narrow face is done according to the operating condition. When applying multiple taper design to this width changing type mold for slab, the problem is that the rate of upper or lower taper changes in different slab width. In this paper, the relationship between multiple taper and the uniformity of the shell growth was discussed considering slab width quantitatively by using computational model and observed shell thickness of slab. By using the developed calculation models, the multiple taper designs were optimized and applied to the actual continuous casting molds’ narrow faces.
著者関連情報
© 2015 一般社団法人日本機械学会
feedback
Top