日本機械学会論文集
Online ISSN : 2187-9761
ISSN-L : 2187-9761

この記事には本公開記事があります。本公開記事を参照してください。
引用する場合も本公開記事を引用してください。

標準流量を参照値とした気体大流速国家計量標準の確立
岩井 彩舩木 達也栗原 昇寺尾 吉哉
著者情報
ジャーナル フリー 早期公開

論文ID: 16-00240

この記事には本公開記事があります。
詳細
抄録

The air speed measurement is important as the quantitative index for the assessment of the building wind-resistance, the indoor thermal environment and the aerodynamic characteristic of high speed vehicles. NMIJ has established the high air speed standard facility and started a calibration service for Pitot-static tubes. This facility covers the air speed range from 40 m/s up to 90 m/s with relative expanded uncertainty (k = 2) of 0.63 %. The reference air speed is derived from the national primary gas flowrate standard. The test section for conversion from flowrate to air speed is installed at the test line of the closed loop gas flowrate calibration facility. The standard air speed at the center of the nozzle exit is obtained by comparing the integral value of the air speed profile and the standard gas flowrate. Against this standard air speed, a dedicated wind tunnel, which serves for daily calibration service, is calibrated by using a total pressure tube as a transfer standard. An internal comparison was carried out between the new wind tunnel and the conventional medium-speed wind tunnel. The comparison result agreed well enough to validate the capability of the new wind tunnel. This paper describes the calibration system, the traceability chain and the uncertainty analysis of the new air speed standard.

著者関連情報
© 2017 一般社団法人日本機械学会
feedback
Top