Background and aims: In Japan, stripping under general anesthesia, lumbar anesthesia and tumescent local anesthesia has been used in the treatment of primary varicose veins due to saphenous vein insufficiency. However endovenous laser ablation (EVLA) using a 980 nm diode laser has received National Health Insurance (NHI) coverage in 2011, while EVLA using a 1470 nm diode laser with a radial 2-ring fiber has received coverage in 2014. As a result, the use of EVLA has become widespread in Japan. We herein report on the results of varicose veins treatment at our hospital.
Subject and methods: Two hundred eighty-nine patients with saphenous vein reflux who received treatment between October 2013 and December 2015 were included in the present study. The surgical results (operating time, complications, ablation rate, linear endovenous energy density [LEED], and the incidence of surgical site infections [SSI]) were retrospectively assessed and compared among the patients who underwent stripping (group A) and those who underwent EVLA (group B) according to the Japan Guidelines for EVLA.
Results: Group A and group B included 49 patients and 240 patients, respectively. Group B comprised 20 patients who underwent EVLA using a 980 nm laser (group B1) and 240 patients who underwent EVLA using a 1470 nm laser (group B2). The operative time in group A was 48 ± 16 minutes, whereas that in group B was 28 ± 10 minutes. The operative time, the length of the treated vein and LEED in groups B1 and B2 were 40 ± 11 and 27 ± 10 minutes, 36 ± 10 and 33 ± 10 cm and 84 ± 10 and 77 ± 18 J/cm², respectively. Furthermore, the mean operative time in group B1 (with no phlebectomy) was 31 ± 9 minutes, whereas that in group B2 (with no phlebectomy) was 22 ± 7 minutes, which was statistically significant (p‹0.05). The level of pain peak was day 1 in group A patients and on days 3-7 in group B1 patients; the group B2 patients felt little pain. Surgical site infection at the phlebectomy site was observed in two group B2 patients. EVLA resulted in an occlusion rate of 99.6% at approximately two years after surgery.
Conclusions: This study showed that EVLA using the 1470-nm laser caused less pain and bruising than EVLA using the 980-nm laser. The operative time of EVLA was approximately 9 minutes shorter than that of stripping. Therefore, EVLA using the 1470-nm laser might be the first treatment of choice for patients with saphenous vein reflux. However conventional surgery remains important because EVLA is not suitable in cases in which the diameter of the saphenous veins is ›20 mm or in patients with highly tortuous veins.

View full abstract

Asian skin has a higher epidermal melanin content, making it more likely to develop adverse pigmentary reactions following laser surgery. The nanosecond lasers are the gold standard for the treatment of pigmented lesions, but the risk of complications, such as post-inflammatory hyperpigmentation, is increased in dark-skinned patients. Intense Pulsed Light (IPL) or long-pulsed lasers are available for treating superficial pigmented lesions, and fewer complications are seen when using these devices compared to the nanosecond lasers. Nanosecond lasers are essential in the treatment of dermal melanosis. Recently, picosecond lasers have been investigated. Picosecond lasers will also play an important role in the treatment of pigmented lesions.

View full abstract

Background and aims: Conventional water jet devices have been used for injecting fluid to lift up lesions during endoscopic submucosal dissection or endoscopic mucosal resection procedures. However, these devices cannot dissect the submucosal layer effectively. Here we aim to elucidate the dissection capability of a laser-induced pulsed water jet and to clarify the mechanism of dissection with layer selectivity.
Materials (Subjects) and methods: Pulsed water jets were ejected from a stainless nozzle by accelerating saline using the energy of a pulsed holmium: yttrium-aluminum-garnet laser. The impact force (strength) of the jet was evaluated using a force meter. Injection of the pulsed jet into the submucosal layer was documented by high-speed imaging. The physical properties of the swine esophagus were evaluated by measuring the breaking strength. Submucosal dissection of the swine esophagus was performed and the resection bed was evaluated histologically.
Results: Submucosal dissection of the esophagus was accomplished at an impact force of 1.11-1.47 N/pulse (laser energy: 1.1-1.5 J/pulse; standoff distance: 60 mm). Histological specimens showed clear dissection at the submucosal layer without thermal injury. The mean static breaking strength of the submucosa (0.11 ± 0.04 MPa) was significantly lower than that of the mucosa (1.32 ± 0.18 MPa), and propria muscle (1.45 ± 0.16 MPa).
Conclusions: The pulsed water jet device showed potential for achieving selective submucosal dissection. It could achieve mucosal, submucosal, and muscle layer selectivity owing to the varied breaking strengths.

View full abstract

Worldwide, the number of cancer cases is increasing. Typically, they are treated by either surgery or chemotherapy. However, these treatments may be undesirable in elderly patients or those who are under medication with antiplatelet drugs. Photodynamic therapy (PDT) represents a potentially attractive treatment option for these types of patients, since it does not involve surgery and has considerably reduced side effects compared to chemotherapy. Porphyrin, one of the most commonly used photosensitizers, has the convenient property of cancer-specific accumulation and therefore, is commonly used in PDT. However, the mechanism by which this cancer-specific accumulation occurs remains unclear. We previously reported that a heme-transport protein, HCP1, was capable of transporting porphyrin compounds. HCP1 expression is associated with increased hypoxia, although the detailed mechanism by which this regulation occurs is also unknown. Here, we review available data on the mechanism of regulation of HCP1 expression through mitochondrial reactive oxygen species (mitROS). Specifically, cancer cells show increased expression of HCP1 compared to normal cells and this over-expression is reduced in cancer cells over-expressing the mitROS scavenging enzyme manganese superoxide dismutase (MnSOD). Thus we conclude that mitROS is involved in regulating HCP1 expression.

View full abstract

Background and aims: The aim of the study was to evaluate and compare the surface microhardness and surface morphology of permanent tooth enamel after Er,Cr:YSGG laser irradiation and Fluoride application.
Materials and methods: One hundred and twenty premolars extracted for orthodontic purpose were used in the study and randomly divided into 6 groups. Group A was not subjected to any treatment. Group B was subjected to Er,Cr:YSGG laser irradiation. Group C was subjected to Er,Cr:YSGG laser irradiation followed by application of 2% NaF gel for 4 minutes. Group D was subjected to laser irradiation and 1.23% APF gel for 4 minutes. Group E was subjected to 2% NaF gel pretreatment technique followed by laser irradiation. Group F was subjected to 1.23% APF gel pretreatment technique followed by laser irradiation. All the test groups were subjected to microhardness testing and scanning electron microscope evaluation at 500 X and 1500 X.
Results: All the treated groups showed an increase in microhardness value in comparison to the control group. The highest increase in microhardness was seen in Group F. Increase in microhardness values of Group B and Group D was not statistically significant as compared to Group A. Scanning Electron Micrographs showed few craters and fine porosities for Group A. These craters and porosities increased in size and often showed glass like appearance after laser irradiation.
Conclusions: It can be suggested by means of present study that Er,Cr:YSGG laser irradiation alone or in combination with fluoride gel is an effective tool to provide resistance against the caries. Significantly higher resistance (p‹ 0.05) was seen when APF gel was used prior to Er,Cr:YSGG laser irradiation and this combination can act as an efficient tool for prevention against dental caries.

View full abstract

Background and aims: Use of laser technology in endodontics has greatly increased in the recent years due to the introduction of new wavelengths and methods and optimal antimicrobial and smear layer removal properties of lasers. This in vitro study aimed to compare the antibacterial effects of diode lasers of 810 nm and 980 nm wavelength on Enterococcus faecalis (E. faecalis) biofilm in the root canal system.
Materials and methods: Fifty single-canal human anterior teeth were cleaned, shaped, sterilized and randomly divided into four groups namely two experimental, one positive and one negative control group. The experimental and positive control groups were inoculated with E. faecalis and incubated for two weeks. The experimental group one (n=20) received 810 nm diode laser irradiation (1.5W) while the experimental group two (n=20) was subjected to 980 nm diode laser irradiation (1.5W). The E. faecalis colony forming units (CFUs) were counted in each root canal before and after laser irradiation.
Results: Laser irradiation significantly decreased the bacterial colony count in both experimental groups. The reduction in microbial count was significantly greater in 810 nm laser group compared to 980 nm laser group.
Conclusions: Irradiation of both 810 and 980 nm lasers significantly decreased the E. faecalis count in the root canal system; 810 nm laser was more effective in decreasing the intracanal microbial load.

View full abstract

Purpose: This study evaluated the micro-tensile bond strength of new and previous composite resin restorations after surface treatment with diamond bur and Er,Cr:YSGG laser at different power settings (2,3 and 4 W).
Materials and methods: Micro-hybride composite resin was inserted in metallic mold 5 X5 X15 mm and cured for 40 sec according to manufacturer's instruction.12 blocks were made. The bonded surfaces of the 12 blocks so obtained were subsequently ground using Silicon Carbide papers 1200 grit, for 15 seconds under running water. Then the samples randomly were divided into 4 groups: (G1) Bur-treated, (G2) Er,Cr:YSGG laser with power of 2 W and energy of 100 mJ, (G3) Er,Cr:YSGG laser with power of 3 W and energy of 150 mJ, (G4) Er,Cr:YSGG laser with power of 4 W and energy of 200 mJ. One sample of each group was analyzed by SEM while, after cutting the blocks to 1 mm2 of area samples, the others samples were mechanically tested by Universal testing machine with the speed of 0.5 mm per minute till fracture point. Data were analysed using One-Way ANOVA and Tukey Test.
Results: T-test showed no significantly differences between G2 and G4(P=0.064) while G3 demonstrated significant differences than G2 (P=0.001) and G4(P=0.000) and also between samples treated with bur (G1) and G2 (P=0.242) ,G3 (P=0.000) ,G4 (P=0.829); G1 didn't significantly differ to G2 and G4(P›0.05), while G1 and G3(P‹0.05).
Conclusions: On surface treatment of repaired composite, samples treated by laser at 3W power showed better condition of micro-tensile bond strength.

View full abstract