1992 年 58 巻 1 号 p. 133-138
In this study, in order to change the overlapping ratio the speed of test piece and abrasive paper were changed widely and a series of experiments were carried out. And it was examined that the overlapping ratio had an effect on wear characteristics. Results obtained are as follows. (1) In the X-direction when the velocity ratio is from 0 to 3, the wear rate is dependent on sliding speed of abrasive belt, and when more than 3, the wear rate is dependent on vibrational velocity. (2) In the Y-direction when the velocity ratio is from 0 to 2, the wear rate is dependent on the rubbing directions, and when more than 3, the wear rate is dependent on vibrational velocity.