抄録
A program for research and development on magnetic bearing suspended rotor dynamics was planned for the Gas Turbine High Temperature Reactor (GTHTR300) plant. The magnetic bearing to suspend the turbo-machine rotor of GTHTR300 is unique because the required load capacity is much larger than that of existing one. The turbo-compressor and generator rotors, each of which is suspended by two radial bearings, pass over the first and the second critical speeds of bending mode, respectively. The rotor design fulfilled the standard limit of vibration amplitude of 75μm at the rated rotational speed by optimising the stiffness of the magnetic bearings. A test apparatus was designed in the program. The test apparatus is composed of 1/3scale two test rotors simulating turbo-compressor and generator rotors which are connected by a flexible coupling or a rigid coupling. Because the load capacity is almost in proportion to the projected area of the bearing, the load capacity of the magnetic bearing is almost 1/10 of the actual one. The test rotors were designed so that their critical speeds and vibration modes match the actual ones. The test will verify the rotor design and demonstrate the rotor vibration control technology of the magnetic bearing. This paper shows the outline of the test device and the test plan for the magnetic bearing suspended rotor system. The present study is entrusted from the Ministry of Education, Culture, Sports, Science and Technology of Japan.
