The Proceedings of the JSME international conference on motion and power transmissions
Online ISSN : 2424-3043
セッションID: GM-02
会議情報
GM-02 STUDY ON THE TOOTH SURFACE MODIFICATION OF HYPOIDGEAR IN FACE HOB SYSTEM(MANUFACTURING OF GEARS)
Shogo KATOHiroki IKEBEJunji HIRAMATSU
著者情報
会議録・要旨集 認証あり

詳細
抄録
Tooth surface modification of hypoidgears is inevitable operation to obtain excellent gears with good performance. However in the case of the face hob cutting, it is considerably complicate for gear engineers, because both side of tooth are cut at once. In this paper, the authors present the procedure to obtain the correction values of machine settings for tooth surface modification in the case of face hob cutting and report that the modification of pressure angle and spiral angle can be achieved perfectly for individual demand of both tooth flanks with little influence on other characteristics of tooth surface. The usefulness of this procedure was certificated by cutting test using the prototype machine.
著者関連情報
© 2009 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top