Application of 3D-printed prosthetic lower beak in an Oriental stork (Ciconia boyciana)

抄録

To our knowledge, ours is the first case of applying a 3D-printed prosthetic beak to an Oriental stork (Ciconia boyciana). A stork in captivity underwent several surgeries for beak fractures, but the lower-mandible fractures failed to be repaired. Therefore, we applied a patient-specific beak prosthesis of titanium alloy and nylon. Because the prosthetic beak could not be maintained due to mandible and soft-tissue inflammation, the stork was euthanized. Still, we confirmed typical behavior and feeding for ~3 months after surgery. This report highlights some of the challenges we encountered and identifies process improvements required for a more successful surgery.