日本機械学会論文集
Online ISSN : 2187-9761
ISSN-L : 2187-9761

この記事には本公開記事があります。本公開記事を参照してください。
引用する場合も本公開記事を引用してください。

超高張力鋼板プレス製品の壁反りを抑制する新成形工法
勝間 秀人
著者情報
ジャーナル オープンアクセス 早期公開

論文ID: 23-00065

この記事には本公開記事があります。
詳細
抄録

In recent years, automobile manufacturing requires both weight reduction for environmental measures and high strength for safety. For this reason, the use of ultra-high tensile strength steel sheets for frame components is increasing. For the application of ultra-high tensile strength steel sheets, it is necessary to pay attention to measures to ensure dimensional accuracy for press forming. Among them, wall curvature countermeasures are very important technologies. In this study, a novel forming method without generating wall curvature was developed using a simple hat model, and then a prototype mold was produced and confirmed. This novel forming method is a combination of the advantages for draw forming and cam bending forming. To form a shape so as not to fracture or wrinkle in a process similar to drawing, and to prevent wall curvature of a vertical wall part of a hat section in a process similar to cam bending. The forming motion consists of downward descent and multi-step sliding while holding the specimen in one forming process. In the FEM analysis before the production of the prototype mold, the conventional forming method and the novel forming method were evaluated from the viewpoint of the wall curvature, and the novel forming method gave the best results with the minimum wall curvature. The evaluation of the formed panel using the prototype mold also gave the same results as the FEM analysis. This paper shows that the developed forming method hardly generates the wall curvature even when the ultra-high tensile steel sheet is used.

著者関連情報
© 2023 一般社団法人日本機械学会

この記事はクリエイティブ・コモンズ [表示 - 非営利 - 改変禁止 4.0 国際]ライセンスの下に提供されています。
https://creativecommons.org/licenses/by-nc-nd/4.0/deed.ja
feedback
Top