抄録
In-process monitoring of interfacial phenomena occurring during sliding can aid additive selection for oils. However, existing in-process measurement methods are unsuitable for evaluating steel-on-steel wear behavior. This study investigated the relationship between lubricant additive-induced changes at friction interfaces and acoustic emission (AE) signals generated during sliding. A reciprocating friction tester with AE sensors installed on both the ball and disk sides was employed to evaluate the wear behavior of steel specimens lubricated with phosphorus-, sulfur-, and combined S/P-based additives. The P-derived reaction film may have contributed to wear suppression in Samples P and SP, while the S-based additive may have influenced low friction in Sample SP. For Sample S, the AE signal increased as the friction coefficient decreased and dropped sharply when it increased. Interrupted tests and surface analysis suggested the presence of S-derived species, and these changes may be associated with film growth and local destruction. The higher ball-side AE signal for Sample S, despite almost no wear on the ball, may reflect disk wear or interfacial phenomena associated with the S-derived reaction film. Our results indicate that AE measurements are effective for the in-process evaluation of friction interface changes associated with wear and reaction film behavior.