THE JOURNAL OF THE ACOUSTICAL SOCIETY OF JAPAN
Online ISSN : 2432-2040
Print ISSN : 0369-4232
Search
Advanced search
OR
Browse
Search
Volume 18, Issue 5
Displaying 1-3 of 3 articles from this issue
Show all abstracts
    • |<
    • <
    • 1
    • >
    • >|
  • Program Time Regulator by Sampling Method
    Gen Nishinomiya
    Article type: Article
    1962 Volume 18 Issue 5 Pages 269-274
    Published: September 30, 1962
    Released on J-STAGE: June 02, 2017
    DOIhttps://doi.org/10.20697/jasj.18.5_269
    JOURNAL FREE ACCESS
    Show abstractHide abstract
    This paper, describes a program time regulator by sampling method using a revolving head assembly, mainly its principle, mechanism for experiment, problems of head scanning, and the effects by the following factors-sampling width, time constant at sampling boundary, regulating rate, etc. The results clarified by this experiment are as follows: 1)To eliminate echo distortion, reproducing output of each magnetic head must be switched by an electronic circuit. 2)In speech, most suitable sampling width was 30 ms. 3)To Resolve the click and the level fluctuation at the sampling boundary, it was affective to set the switching time constant at 2〜3 ms. 4)In the case of large rate of regulation such as about 100% expansion or 50% compression, too the intelligibility was little destroyed.
    View full abstract
    Download PDF (616K)
  • Design Conditions of the Damped Pipe for the Directional Ribbon Microphone
    Akio Mizoguchi
    Article type: Article
    1962 Volume 18 Issue 5 Pages 275-285
    Published: September 30, 1962
    Released on J-STAGE: June 02, 2017
    DOIhttps://doi.org/10.20697/jasj.18.5_275
    JOURNAL FREE ACCESS
    Show abstractHide abstract
    This paper describes the design conditions for the damped pipe used in the directional ribbon microphone. The relationship between the throat impedance of the damped pipe and the frequency and directional reponse of the directional ribbon microphone was analyzed. The necessary pipe length and the approriate quantity of sound absorbing material contained in the pipe were obtained to provide the microphone with a uniform directional response down to the low frequency range. Furthermore, the dimention and form of the pipe were reexamined to give a flat frequency response.
    View full abstract
    Download PDF (915K)
  • [title in Japanese]
    [in Japanese]
    Article type: Article
    1962 Volume 18 Issue 5 Pages 286-
    Published: September 30, 1962
    Released on J-STAGE: June 02, 2017
    DOIhttps://doi.org/10.20697/jasj.18.5_286
    JOURNAL FREE ACCESS
    Download PDF (138K)
    • |<
    • <
    • 1
    • >
    • >|
feedback
 Top