A new analytical method is proposed for determining the inextensible grid reinforcement pullout resistance and pullout force/pullout displacement curve by using basic backfill soil and grid reinforcement properties. The pullout skin friction resistance/pullout displacement relationship is simulated by linear elastic-perfectly plastic model. A hyperbolic model has been proposed to represent the pullout bearing resistance/pullout displacement relationship in which the maximum bearing resistance of a single bearing member is determined using a new bearing capacity equation proposed in this paper. The influences of the grid bearing member spacing ratio, S/, the bearing member deflection rigidity, and the pullout softening behavior on the mobilization of pullout bearing resistance are explicitly included in the proposed model. Good agreement has been obtained between calculated values and laboratory test results.

抄録全体を表示

This paper outlines a mathematical description of the stress dilatancy behaviour of granular materials which accounts for stress level and void ratio dependencies. The consideration of these aspects has important implications in the modelling of granular material behaviour. In fact, granular material mechanical response is largely dominated by the evolution of dilatancy, fabric and void ratio histories. The starting point in this study is the well established Rowe's theory which is revisited and ultimately modified by introducing a factor linked to governing state parameters in order to describe the complete behaviour of granular materials during deformation. Numerical simulations of triaxial tests on granular materials at different void ratios and stress levels are herein presented to illustrate the model.

抄録全体を表示

The present paper aims at developing a simplified model for a stress-strain relationship at small strains up to an initial yielding of homogeneous saturated frozen sand. The modelling of elastic moduli for an ice-sand mixture as a composite geomaterial is first introduced based on previous studies, where a saturated frozen sand is treated as the icesand mixture. The applicability of modelling the elastic moduli under constant temperature is then discussed from the theoretical and experimental points of view. In addition, the hyperbolic stress-strain modelling of saturated frozen sand at small strain is presented. The effect of the volume fraction of sand, stiffness of sand inclusion and temperature changes on the elastic moduli and the stress-strain behaviour up to about 1-2% axial strain, which is defined as an upper yield stress, are investigated through the model, whose applicability is verified in comparison with the experimental data.

抄録全体を表示

The advantages and disadvantages of using a back analysis of slope failures to evaluate soil shear strength are discussed. A methodology is presented herein that allows the implied level of reliability associated with soil shear strength parameters back calculated from slope failures to be estimated. A reliability approach is also used to estimate the probability of failure for a given limit equilibrium slope stability method, design factor of safety, and combination of back calculated Mohr-Coulomb shear strength parameters, c' and φ'. The methodology is illustrated using 39 landslides in the Orinda Formation in the San Francisco Bay area. The impact of additional case histories in the same geologic setting, i.., a larger data set, on the required design factor of safety for a given probability of failure is also investigated.

抄録全体を表示

Two new partially saturated tricyclic ring systems, , a, 7, , , 10, 10a, 11-octahydro-11-oxodibenz [, ] oxepins (a and ), and -thiepins (4a and 4) were synthesized. Compounds 4a and 4 were desulfurized to give a pair of isomeric 2-methylbenzoylcyclohexanes (10a and 10). Deuterated 4a and 4 (11a and 11) were prepared starting from butadiene- (12). The stereochemical features of a (trans), (cis), 4a (trans) and 4 (cis) are compared with those of 10a, 10, 11a and 11 on the basis of proton nuclear magnetic resonance data.

抄録全体を表示

11-Amino-, a, 7, , , 10, 10a, 11-octahydrodibebenzo[, ]thiepines (a-) and -oxepines (7a-) were synthesized by the Leuckart reaction of , a, 7, , , 10, 10a, 11-octahydro-11-oxodibenzo[, ]thiepines (1a, )and -oxepines (2a, ) followed by hydrolysis of the reaction products 4a- and a-, respectively. The four diastereomers, cis(a-H, 10a-H)-cis(10a-H, 11-H) a and 7a, cis(a-H, 10a-H)-trans(10a-H, 11-H) and 7, trans(a-H, 10a-H)-trans(10a-H, 11a-H)c and 7c, and trans(a-H, 10a-H)-cis(10a-H, 11-H) and 7, were isolated and their configurations and conformations were elucidated by chemical methods together with ¹H-nuclear magnetic resonance spectroscopic and X-ray crystallographic analyses.

抄録全体を表示

From the fronds of Polystichum tripteron (KUNZE) P_R. a new norcarotenoid glycoside was isolated and shown to be (R, 7, R)--hydroxy-megastigma-4, 7-dien--one--O-β--glucoside. The fronds of Dennstaedtia wilfordii (MOORE) CHRIST. contain the same glucoside.

抄録全体を表示

The objective of this paper is to develop a new vibro-compaction machine by investigating experimentally the effects of the frequency of an oscillator mounted on a tracked vehicle on the vibro-compaction of a high lifted decomposed granite sandy soil. By measuring the amount of depression of the ground surface, the dry density distribution in depth using a cone penetrometer, the normal earth pressure distribution in depth using a soil stress transducer, and the vertical and horizontal acceleration distribution in depth, the effects of the tracked vehicle on the increment of the soil compacting dry density in a deep stratum were considered theoretically for various kinds of frequency. It was observed that an oscillator frequency of 16 Hz with a constant amplitude of exciting force of . kN showed the maximum amount of depression of the ground surface and the maximum dry density distribution at deep stratum for the range of frequency from 16 Hz to 51 Hz. The ratio of dynamic shear stress to normal stress at 16 Hz proved to be large enough at deep stratum, so that an optimal alternative shear strain due to the impact force was developed on the whole range of the high lifted stratum. It was assumed that the increment in soil compacting density was the result of the effective dilatancy phenomenon.

抄録全体を表示

Repetitive liquefactions in angular and subangular gravels from an alluvial fan, in the case of two earthquakes with accelerations lower than that of a former which had caused liquefaction some months before, are described. The liquefaction took place from the surface, down to a depth of approximately 10 m. Water laden with sediments spouted out for some tens of minutes after the strong motion ceased. Knowledge of the grain size distribution of the sediments inside the body of the alluvial fan roughly defines the areas of the fan prone to future liquefaction. Non-repetitive liquefaction in overconsolidated fine fluvio-lacustrine sand of glacial origin at the unusual depth of 14 m to 16 m is also described. From the observation of sand lifted up for 10 m inside a large diameter well, and of that which spouted out from several microvents, it was estimated that extra-pore pressure was close to lithostatic conditions. Nevertheless, modeling of intrinsic pore pressure buildup on the DESRA2 programme gives lower values than the experimental one. Geotechnical characteristics of the 12 m-thick sandy stratum indicate that the upper part is unusually soft, either due to water circulation or past repetitive liquefactions which prevented reconsolidation. It is suggested that excess pore pressure generated by the earthquake was also due to redistribution of pressure from adjacent sediments.

抄録全体を表示

 The stability of

‒tetrahydrocannabinol acetate (‒THC‒OAc) and ‒tetrahydrocannabinol acetate (‒THC‒OAc) in -liquid during storage was investigated. ‒THC‒OAc liquids in cartridges were stored at 80℃ or 30℃ for 28 days. The relative concentrations of cannabinoids in the liquids were measured by gas chromatography with flame ionization detection. ‒THC‒OAc decreased during storage at either temperature. ‒THC, a minor impurity, also decreased. ‒THC‒OAc liquid in a cartridge was stored at 80℃ for 57 days. The concentration of ‒THC‒OAc and ‒THC, a minor impurity, did not change during that time. Cannabinol acetate increased in all liquids, and unknown products were also detected by gas chromatography/mass spectrometry (GC/MS). The ‒THC‒OAc and ‒THC‒OAc liquids were subjected to GC/MS to detect representative diluents, glycerol, propylene glycol, and polyethylene glycol 400, but none of these were detected.

抄録全体を表示

In this study the field feasibility of an innovative thermal technique to improve the performance of prefabricated vertical drains (PVD) used in conjunction with the preloading ground improvement method is investigated. For this purpose, two identical .0 m high full-scale test embankments for preloading were constructed over the soft Bangkok clay where a conventional PVD system was installed underneath one embankment and a novel prefabricated vertical thermo-drain (PVTD) system was utilized for the other. The PVTD unit consists of a U-tube made of cross-linked polyethylene plastic (PEX) that is attached to a conventional PVD unit. Preheated water at about 90°C is circulated through the attached U-tube to raise the soil temperature underneath the PVTD embankment. The behavior of the two test embankments were compared in terms of excess pore water pressure and consolidation results. The comparison shows the advantage of a PVTD system over a conventional PVD system. The rate of consolidation increases significantly in the PVTD system due to the temperature effect on the hydraulic conductivity. Moreover, the embankment with the PVTD system generates more settlement due to the thermally induced irreversible contraction of saturated normally consolidated soft Bangkok clay.

抄録全体を表示

As a fundamental study on dibenzothiepins, reaction of 11-phenyl-, 11-dihydrodibenzo [, ] thiepin-11-ol (10) or 11-chloro-11-phenyl-, 11-dihydrodibenzo [, ] thiepin (14) with triphenylmethyl cation or was examined under various conditions. 11-Phenyl-, 11-dihydrodibenzo [, ] thiepin-11-ylium salt () was isolated as a black powder (perchlorate) and a green powder (hexachloroantimonate), but BF₄ salt was obtained only as a solution. Treatment of the hexachloroantimonate with excess of was found to result in a novel dehydrocyclization reaction to give selectively , 13-dihydrofluoreno [1, a, -c, ] [2]-benzothiepin-13-ylium hexachloroantimonate (19). Some discussions were made on the mechanism of the formation of 19.

抄録全体を表示

The main objective of this paper is to compare safety factors obtained from Morgenstern-Price, Janbu and Spencer methods with the factors calculated from the modified variational approach (Leshchinsky and Huang, 1992a). Such comparison is essential since there is no mathematical proof that the variational analysis indeed yields a minimum and thus, physically produce significant results. The safety factors compared well, indicating the variational analysis is on a par with acceptable existing rigorous methods. Availability of a user-friendly computer code may make the variational analysis useful to practicing engineers. However, its greatest potential at the moment is in - applications; i.., unlike other methods, its extension to - is straightforward.

抄録全体を表示

わが国における主要中晩生および香酸カンキツ染色体のクロモマイシン (CMA) 染色を行った. 染色体はCMA(+) バンドの有無および位置から種類に区分できた. すなわち, CMA(+) をA: 両端および動原体近傍に有する, : 一方の端部と動原体近傍に有する, C: 両端に有する, : 一方の端部に有する, : CMA(+) がない, である. 各種はこれらのうち4, 種類の染色体を有し, 独自のCMAバンドパターンを示した. ハッサクでは1A+1C++, ヒュウガナツでは2A+2C++, ‘川野なつだいだい’では1A+2C+7+, ‘宮内伊予柑’では1A+1+1C++7, タンカン‘垂水1号’では1A+1+1C++7, カボスでは+2C++, スダチでは1+2C++およびユズ‘山根’では2+1C+11+4であった. 以上の結果, 本研究においても近縁の種間では似通ったCMAバンドパターンが観察された.

抄録全体を表示

The correction factor (η_ie) for the ultimate bearing capacity of a footing placed adjacent to a slope, taking into account the combined effect of horizontal and vertical seismic loads, represented by horizontal and vertical seismic coefficients, k_h and k_v, respectively, was derived using a modified Janbu's slice method. The influence of slope angles ‘α’ on the values of ‘η_ie’ are studied here. It was found that the values of η_ie can be expressed as an exponential function of ‘k_h/(1-k_v)’ and ‘α’, with a measurable interdependency between ‘α’ and ‘η_ie’. The influence of ‘α’ on the value of ‘η_ie’ increases as the input value of ‘k_h/(1-k_v)’ increases. Equations derived based on the analytical results are proposed to account for this effect. Based on the analyses of 11 near-fault seismographers obtained in the 1999 Chi-Chi earthquake in Taiwan, a ratio between the vertical and the horizontal seismic coefficients, λ, of between ±0.25 is suggested for including the combined effect of vertical and horizontal seismic forces in evaluating the seismic bearing capacity of footings located in near-fault areas.

抄録全体を表示

At present, analytical or empirical formula for seismic bearing capacity of footings adjacent to slopes is not available. This study uses a pseudo-static-based approach in conjunction with rigorous Janbu's slice method to derive analytical values of seismic bearing capacity factors (N_γ) and correction factors for the effects of inertia of soil mass and load inclinations for a rigid footing adjacent to cohesionless slopes. It is shown that both the bearing capacity factors (N_γ) and the correction factors for the seismic bearing capacity of footings placed on level ground derived herein are comparable with those reported in the literature. Empirical equations regarding the effects of slope angles and load inclinations, expressed using generalized forms of those proposed in the literature, are also derived. It is also found that the empirical equations derived in the present study provide values of correction factors in good agreements with the analytical ones, indicating the validity of using these empirical equations for assessing the bearing capacity of rigid footings situated on the slope subjected to pseudo-static seismic loading.

抄録全体を表示