Abstract
The purpose of this study was to design an optimum glass fiber-reinforced composite (FRC) clasp. Three-dimensional finite element models were constructed of FRC circumferential clasp arms and an abutment tooth. The basic clasp arm was half-oval, without a taper, 2.60 mm wide and 1.30 mm thick. Four modified clasp arms were prepared by changing the width or thickness of the basic clasp (width/thickness: 2.60 mm/0.65 mm, 2.60 mm/1.95 mm, 1.30 mm/1.30 mm, and 3.90 mm/1.30 mm). Forced displacements of 5 mm in the removal direction were applied to the nodes at the base of the clasp arm. The retentive forces and maximum tensile stresses of the five FRC clasp arms ranged from 1.00–16.30 N and from 58.9–151 MPa, respectively. Results showed that an optimum FRC clasp was a circumferential clasp with 2.60 mm width and 1.30 mm thickness, which had sufficient retentive force and low risk of tensile failure.
