抄録
Purpose: The purpose of this in vitro study was to assess the effect of varying the margin designs and the occlusal thicknesses on the fracture resistance and mode of failures of endodontically treated teeth restored with polymer infiltrated ceramic endocrown restorations.
Methods: Root canal treated mandibular molars were divided into four groups (n = 8) and were prepared to receive Computer-Aided Design/Computer-Aided Manufacturing (CAD/CAM) fabricated polymer infiltrated ceramic endocrowns (ENAMIC blocks). Group B2 represents teeth prepared with a butt joint design receiving endocrowns with 2 mm occlusal thickness and the same for group B3.5 but with 3.5 mm occlusal thickness. Group S2 represents teeth prepared with 1 mm shoulder finish line receiving endocrowns with 2 mm occlusal thickness and the same for group S3.5 but with 3.5 mm occlusal thickness. After cementation and thermal aging, fracture resistance test was performed and failure modes were observed.
Results: Group S3.5 showed the highest mean fracture load value (1.27±0.31 kN). Endocrowns with shoulder finish line had significantly higher mean fracture resistance values than endocrowns with butt margin (p < 0.05). However, the results were not statistically significant regarding the restoration thickness. Evaluation of the fracture modes revealed no statistically significant difference between the modes of failure of tested groups.
Conclusions: For the restoration of endodontically treated teeth, adding a short axial wall and shoulder finish line can increase the fracture resistance. However, further investigations, especially the fatigue behavior, are needed to ensure this effect applies with small increases of restoration thickness.
