機素潤滑設計部門講演会講演論文集
Online ISSN : 2424-3051
会議情報
202 アクティブバルブを用いた共振駆動形圧電マイクロポンプ : 負荷特性と小形化の検討
朴 重濠吉田 和弘石川 主税横田 眞一瀬戸 毅高城 邦彦
著者情報
会議録・要旨集 フリー

p. 77-80

詳細
抄録
We have been developing a resonantly-driven piezoelectric micropump using active-type check valves in place of conventional passive-type. It actively controls open/close motion of check valves using piezoelectric actuator installed into inlet and outlet. In the previous paper, frequency characteristics of the flow rate without load pressure were investigated using a prototype micropump fabricated with the effective size of 17×8×11(mm)^3. In this paper, load characteristics and bi-directional flow characteristics are experimentally investigated using an adequate timing control for valve closing motion. Maximum flow rate of 65(mm)^3/s and maximum pressure of 0.2MPa are obtained at the driving frequency of 2.8kHz. Besides, it is ascertained that optimal values of phase shift against voltage for driving pump chamber are 15° for inlet check valve and 195° for outlet. Based on the obtained results, a sheet-type active shuttle valve that has a unified valve-body for inlet and outlet check valves is proposed and a novel micropump with the effective size of 10×10×10(mm)^3 using the shuttle valve is fabricated and tested.
著者関連情報
© 2003 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top