Deformation Characteristics Evaluation of Modified Equal Channel Angular Pressing Processes

Seung Chae Yoon; Anumalasetty Venkata Nagasekhar; Ji Hoon Yoo; Mohamed Ibrahim Abd El Aal; Majid Vaseghi; Hyoung Seop Kim

doi:10.2320/matertrans.MB200906

この記事には本公開記事があります。本公開記事を参照してください。
引用する場合も本公開記事を引用してください。

Deformation Characteristics Evaluation of Modified Equal Channel Angular Pressing Processes

Seung Chae Yoon, Anumalasetty Venkata Nagasekhar, Ji Hoon Yoo, Mohamed Ibrahim Abd El Aal, Majid Vaseghi, Hyoung Seop Kim

著者情報

キーワード: equal channel angular pressing (ECAP), severe plastic deformation (SPD), T-ECAP, cross-ECAP, equal channel multi-angular pressing (ECMAP), finite element analysis

ジャーナル認証あり早期公開

論文ID: MB200906

DOI https://doi.org/10.2320/matertrans.MB200906

この記事には本公開記事があります。

The final version of this article is now available: Vol. 51 (2010) , No. 1 p.46

詳細

抄録

In current studies, equal channel angular pressing process (ECAP) and modified ECAP processes are simulated under ideal conditions to compare the deformation characteristics. The deformation behaviour is more complicated and the strain induced during the processes is highly non-uniform in the modified ECAP processes except in the equal channel multi-angular pressing (ECMAP) process with Route C. The strain homogeneity is more of a possibility with ECAP and ECMAP with Route C processes. The deformation stress state is widely distributed in nature in modified ECAP processes than in conventional ECAP. In addition, the load requirements are also higher in modified ECAP processes with that of the ECAP process.

責任著者(Corresponding author)

J-STAGEへの登録はこちら（無料）