鉄と鋼
Online ISSN : 1883-2954
Print ISSN : 0021-1575
ISSN-L : 0021-1575
特集「熱間圧延ロールの課題の克服」
熱間薄板圧延時の絞り込みのシミュレーション
小森 和武
著者情報
ジャーナル オープンアクセス HTML

2018 年 104 巻 12 号 p. 742-749

詳細
抄録

In hot sheet rolling, the sheet end often snakes, contacts the side guide, buckles, and goes into the roll gap, while the overlapped sheet end is squeezed. Although many simulations on sheet snaking are reported, very few researches have been performed to simulate both the sheet snaking and sheet buckling. In this study, we proposed a combined method to simultaneously simulate the sheet snaking through the rigid-plastic FEM and to analyze the sheet buckling by the elementary theory of buckling. The in-plane lateral load and the in-plane bending moment were assumed at the surface of the region for the simulation by the rigid-plastic FEM. The amount of snaking at the sheet end simulated by the rigid-plastic FEM agreed with that calculated from the analysis by the elementary theory. Finally, we clarified the effects of rolling conditions on the occurrence of squeezing, such as the difference in the sheet thickness in the roll axis direction, the difference in the roll gap in the roll axis direction, and the amount of the off-center.

著者関連情報
© 2018 一般社団法人 日本鉄鋼協会

This article is licensed under a Creative Commons [Attribution-NonCommercial-NoDerivatives 4.0 International] license.
https://creativecommons.org/licenses/by-nc-nd/4.0/
前の記事 次の記事
feedback
Top