It has been shown after mathematical and mechanical investigation that Limit Equilibrium Method (LEM) can be considered as a method to obtain the necessary condition of Slip Line Method (SLM), and that the solution can be obtained under the condition that F_s=1 and ∂F_s/∂θ=O, where F_s is the safety factor and θ is the inclination of the plane on which the safety factor is defined. Next, the generalized LEM (GLEM) is proposed, dealing with the following points : (1) Triangular or quadrangular blocks can be treated; (2) Safety factors are defined also on interblock planes; and () All types of plastic problems, slope stability, bearing capacity, and earth pressure are identically formulated. Two situations regarding treatment of the moment equilibrium condition are discussed. GLEM is applied to well-known problems. The results agree well with those obtained by theoretical methods. GLEM can be used to obtain the distribution of earth pressure or bearing capacity. GLEM, Iike ordinary LEM, is very effective for the practical problems, but GLEM is more theoretical and it can result in more accurate solutions.

抄録全体を表示

The design implication of stress-confinement effect of nonwoven geotextile is addressed. The unconfined and confined strengths of a selected needle-punched nonwoven geotextile are used to conduct a comparative design of a granular soil retaining wall based on a limit equilibrium approach. A higher wall may be allowed when considering the confined strength as compared to the unconfined strength. For a selected wall height, confined strength allows for fewer geotextile layers when compared to that designed using unconfined strength. It is recommended that stress-confinement test procedure should be standardized so that confinement effect of some nonwoven geotextiles may be incorporated into an individual wall design procedure.

抄録全体を表示

We screened the differentiation-inducing activities of 39 mushroom extracts from Akita prefecture, Japan, on the mouse osteoblastic cell line, MCT-1. Sixteen phosphate buffered saline (PBS), 8 boiled PBS, 14 ethanol and 12 methanol extracts induced alkaline phosphatase (ALP) activities, an indicator of MCT-1 cell differentiation. The enzyme activities were markedly induced by extracts of Tricholoma auratum, and we isolated the active compound from methanol extracts of this mushroom. Physical data for the isolated active compound were identical to those for (,24R)-ergosta-,-diene-,,-triol (1). 1 induced ALP activities of MCT-1 cells and promoted cell proliferation. To investigate the relationships between the chemical structure and differentiation-inducing activity of the compound, ALP-inducing activities of MCT-1 cells by 1, ergosterol (2), ergocalciferol (), cholesta-,,-triol (4), -dehydrocholesterol () and cholecalciferol () were tested. The enzyme activities of MCT-1 cells were increased .-fold by 10 μM 1 and 2.4-fold by 10 μM 4. However, 2, , and did not induce MCT-1 cell ALP activity at .1—10 μM. These results suggested that the OH groups at C- and/or C- of 1 and 4 played an important role in their differentiation-inducing activities on MCT-1 cells. Furthermore, 1 suppressed induction of MCT-1 cell apoptosis by serum starvation.

抄録全体を表示

Static characteristics of two different structured InAlGaAs/InAlAs superlattice avalanche photodiodes (SLAPDs) cooled by liquid nitrogen were evaluated at a wavelength of 1. μm. The dark current of the SLAPD having a thick superlattice layer of .504 μm was ×10^-13 A. This was successively reduced by four orders of magnitude compared to that of the thin layer SLAPD of .231 μm at a breakdown voltage of around 20 V. The thickened layer was effective in suppressing tunneling dark current. An output current of 1.×10^-12 A at a bias voltage of 15 V was measured for an optical input with a wavelength of 1. μm and a signal power of 1×10^-12 W. This showed a sharp distinction from the dark current.

抄録全体を表示

[1] The purpose of this reserch is to make clear what type of design can give good effects to win the high readership score. At the begining I had to know what factors decide the readership score, and how to change the quality of the desing into numerical value. I have used the method of multi-dimentional analysis with the help of a computer, and got the estimation formula, with kinds of factors, as follows ; A^^〜=+C+D+K+++cG. A^^〜=estimated values of the readership score. 1) , C, D, K : these four factors are given as category values (so we call them); each factor is classified into several categories. =week day, classified into categories. C=pages of a newspaper, which are characterized by the kinds of articles, news, and the other reading matters, classified into categories. D=kinds of goods and trades of the advertizement, classified into 14 catedories. K=constants, given to each 13 surveys. 2) , F, G : these factors are given as numerical values. G=area of advertizement, measured by the unit of column in the whole page length, being classified into kinds of area (2., ., , , 10, 15) and 15 column means a whole page, about 2,000cm^2. , F are the marks obtained in the design of advertizements. =sum of the marks obtained in each design element on the advertizement. F=the marks obtained on the whole effect of the design. ) a, , c : coefficients Using the above formula with the category values and the coefficients, we can obtain the naked design effect from the actual value A of readership score: +=A-(+C+D+K+cG). In this research, I used 1,829 data of readership score from 1960 to 1968, being obtained by 13 survevs, spring and autumn twice a year. The sample of size each survey was ,541, 2,251, or 200 in the other 11 surveys. Multiple correlation coefficient between the estimated value A^^〜 and the actual value A is .951. The table 2^* shows the contribution indexes of each factor by kinds of expression-(1) Range : the absolute difference between the maximum and the minimum category values, (2) Standard deviations of the category values, () Partial correlation coefficient : the relationship between the actual values A and each factors. *see the table 2 in the thesis in Japanese. [2] The important point was in the determination of the values of , F. is the sum of the marks obtained in each design element, classified into four kinds : =_1+_2+_+_4. design elements [table] _1, _2, _, _4, these values have the grades, as , 1, 2, , 4 and is given to the design that has no attractive effect or no applicable element. And obtain the marks of to grades as the sum of them. The values of F have also grades, to 4. The principles to determine the values of , F are as follows : a) The marks obtained of , F must be the relative values among the each survey, and at the same time, they must have constancy within the same survey-the same elements of design must win the same marks obtained. ) They must be determined as to win the highest multiple correlation coefficient, when they are put into the estimation formula. c) They must be reasonable. In order to justify them, we must carry many researches on the actual condition. The frequency of accurence of each grade of , F values, as the table -4, and - in the thesis in Japanese.

抄録全体を表示

The saponin fraction from the seeds of the tea plant [Camellia sinensis (L.) O. KUNTZE (Theaceae)] was found to exhibit potent protective effects on ethanol- and indomethacin-induced gastric mucosal lesions in rats. Five new triterpene saponins, theasaponins (1), (2), (), (4), and (), were isolated together with 11 known saponins from the saponin fraction. The chemical structures of 1— were elucidated on the basis of chemical and physicochemical evidence. Among the isolated saponins, theasaponins (), (), and () and assamsaponin C (10) showed an inhibitory effect on ethanol-induced gastric mucosal lesions at a dose of . mg/kg, p.o. and their activities were stronger than that of omeplazole. With regard to the structure–activity relationships of theasaponins, the following structural requirements for a protective effect on ethanol-induced gastric lesions were suggested; 1) the 21- and/or -acyl groups are essential for the activity, 2) acetylation of the 16-hydroxyl group reduce the activity.

抄録全体を表示

The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–1,500 μm tall). On 2% modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

This paper outlines a mathematical description of the stress dilatancy behaviour of granular materials which accounts for stress level and void ratio dependencies. The consideration of these aspects has important implications in the modelling of granular material behaviour. In fact, granular material mechanical response is largely dominated by the evolution of dilatancy, fabric and void ratio histories. The starting point in this study is the well established Rowe's theory which is revisited and ultimately modified by introducing a factor linked to governing state parameters in order to describe the complete behaviour of granular materials during deformation. Numerical simulations of triaxial tests on granular materials at different void ratios and stress levels are herein presented to illustrate the model.

抄録全体を表示

Some existing analytical methods which have been used in geotechnical engineering are modified to handle the shear strength reduction with time due to softening in fissured, over-consolidated clays and mudstones. These are limit equilibrium analysis of slope stability, calculation of earth pressure and calculation of stress and displacement around a tunnel. The softening effect is incorporated in these analyses using the failure criterion and the time-dependent strength parameters proposed previously by the authors. Examples are presented which emphasize the importance of appreciating the softening effect in analyses and further illustrate that the effect of shear strength reduction with time due to softening could easily be captured with existing analytical methods.

抄録全体を表示

Circuit techniques to enhance the linearity of input-voltage-to-current (V/I) conversion and to increase the output impedance of a current source by compensating for the low intrinsic gain of a transistor were introduced to realize a high-frequency operational transconductance amplifier (OTA) for a low supply voltage using sub-100-nm CMOS processes. Applying these techniques, a MOS th-order Gm-C linear-phase low-pass filter (LPF) was realized using a 65nm CMOS process. A simplified biquad LPF that can serve as a component of a th-order LPF was newly developed by replacing OTAs with resistors. As a result, the -dB frequency bandwidth, group delay ripple, rd-order distortion, and rd-order input intercept point (IIP) were 200MHz, 2.2%, ≤ -55dB with a 100MHz input, and +10.dBm, respectively, all with a ±.1Vp-p input signal at each input terminal in the pseudodifferential configuration. The LPF including an output buffer dissipated 60mW in the case of a 1.2V supply. Wide spurious-free dynamic range (SFDR) characteristics were confirmed up to high frequencies.

抄録全体を表示