材料
Online ISSN : 1880-7488
Print ISSN : 0514-5163
ISSN-L : 0514-5163
マシニングセンタによる高速重切削面のX線残留応力評価
井上 靖雄雨宮 健柏谷 賢治
著者情報
ジャーナル フリー

2000 年 49 巻 9 号 p. 963-969

詳細
抄録

The effects of cutting speed, feed rate and cutting depth are investigated on the residual stress in the surfaces, which are machined by a machining center, by the measurements using a X-ray residual stress and the texture.
It is found that the pole figures in the surfaces machined by the machining center are different from those by shaping machines and horizontal milling machines. The texture of cut surface by the shaping machines and horizontal milling machines is the rolling texture, on the other hand the texture of cut surface by the machining center is a weak texture similar to that of the initial stages due to rolling contact fatigue.
In cutting by the machining center, the residual stress increases as the cutting speed increases and it decreases as the feed rate and cutting depth increase because of the influence of the chips. It is found that the residual stress occurred by the machining center is a half time smaller than that by the horizontal milling machines under the optimal cutting condition.
Based on the results obtained from the measurement of texture and X-ray residual stress, it can be concluded that machining with shaping machines and horizontal milling machines shows heavy machining as the feature, while high-speed heavy machining with a machining center indicates easygoing processing from the viewpoint of the crystal deformation behavior, neglecting the damage of tools.

著者関連情報
© 日本材料学会
次の記事
feedback
Top