2018 Volume 35 Pages 200-208
The compression and relaxation characteristics of municipal solid waste (MSW) refuse-derived-fuel (RDF) fluff were investigated with respect to biodegradable fraction, grind size, moisture content, applied load, and pelleting temperature. Experimental trials were performed by using a single pelleting unit mounted on an Instron universal testing machine. Two grind sizes of each sample were prepared, 3.18 mm and 6.35 mm, and moisture contents were increased to 8 %, 12 %, and 16 % w.b. The applied loads were set at 2 kN, 3 kN, and 4 kN at two temperature settings, 50 °C and 90 °C. The experimental data for these trials was collected and multiple compression and relaxation models were fitted to the applied pressure, compact density or volume data. The results indicated that the compact density of RDF improved by increasing the grind size, while the compact density of biodegradable pellets increased with increasing pelleting load and temperature. The compact density of pellets produced from RDF ranged from 880–1020 kg/m3; the compact density of the biodegradable pellets ranged from 1120–1290 kg/m3. The Walker and Jones models both indicated that the biodegradable material fraction has a higher compressibility than the RDF material, where neither moisture content nor grind size at all levels had a significant effect on the compressibility of either material. The Kawakita-Lüdde model estimated the porosity of the pelleted samples, while the Cooper-Eaton model indicated that the primary mechanism of densification was particle rearrangement. Application of the Peleg and Moreyra model for analysis of relaxation properties of the compressed materials determined the asymptotic modulus of the residual stress to be between 89 and 117 MPa for all experimental parameters; however, the RDF material produced more rigid pellets than the biodegradable material.
https://ror.org/010x8gc63 
