CORROSION ENGINEERING DIGEST
Online ISSN : 1884-1155
Print ISSN : 0010-9355
ISSN-L : 0010-9355
Volume 17, Issue 5
Displaying 1-5 of 5 articles from this issue
  • Shigeru Kishima
    1968 Volume 17 Issue 5 Pages 193-201
    Published: May 15, 1968
    Released on J-STAGE: November 25, 2009
    JOURNAL FREE ACCESS
    A study was made of the effect of cold work on the stress-corrosion cracking susceptibility of some commercial F. C. C. alloys, i.e. two different heats of Type 301 steel, one heat of Type 310 steel, and one heat of 70/30 brass. The specimens, prepared from annealed and cold worked sheets, were stressed by cantilever method and exposed to boiling 35% aqueous MgCl2 solution (in the case of stainless steel) or to 0.94M aqueous ammonia solution containing small amounts of Na2CrO4 and NaCl (in the case of brass). The susceptibility was determined by recording the time to failure in the test solutions.
    The effect of cold work on the stress-corrosion cracking must be explained on the basis of the physical and metallurgical changes produced by cold working, such as work-hardening, heterogeneous distribution of tensile stress, and martensitic transformation. It is therefore different according to the stress level applied. It can be said that, when the cold worked specimen is loaded at the stress around its yield strength, the susceptibility depends on its deformability. This fact suggests that the stress-corrosion cracking process involves a brittle fracture step. If the stress applied is far below the yield strength of the specimen in question, the susceptibility would be determined by a competitive action between strengthening of material and heterogenizing of stress distribution. Whether the phase formed by martensitic transformation hinders stresscorrosion cracking or not depends both on the stress level applied and on the degree of prior cold working. In general quasi-martensite lowers the susceptibility to stress-corrosion cracking. Potential measurements under tensile stress were also made.
    Download PDF (1200K)
  • Synergism of Anions and Amines
    Takao Murakawa, Toshiharu Katô, Shigeo Nagaura
    1968 Volume 17 Issue 5 Pages 202-207
    Published: May 15, 1968
    Released on J-STAGE: November 25, 2009
    JOURNAL FREE ACCESS
    Concerning the synergistic action of anions and amines for the corrosion inhibition of iron in acid solutions, three different models, depending on the kinds of anions and amines, have been proposed. In perchloric acid solutions, primary fatty amines adsorb over the Br--covered iron surface as ammonium cations, while tertiary fatty amines adsorb on the iron surface as: NR together with Br- anions. These two different models are called, respectively, overlap adsorption and coadsorption. Some organic acids and amines also show a synergistic effect for the corrosion inhibition of iron in perchloric acid solutions. Mechanism for this case can be explained in terms of the electrostatic coadsorption of RCOO-, which is the adsorbed species of organic acid, and (NRH)+ cation.
    Download PDF (819K)
  • [in Japanese]
    1968 Volume 17 Issue 5 Pages 208-222
    Published: May 15, 1968
    Released on J-STAGE: November 25, 2009
    JOURNAL FREE ACCESS
    Download PDF (2262K)
  • Diane G. Mason, [in Japanese], [in Japanese]
    1968 Volume 17 Issue 5 Pages 223-225
    Published: May 15, 1968
    Released on J-STAGE: November 25, 2009
    JOURNAL FREE ACCESS
    Download PDF (1795K)
  • [in Japanese]
    1968 Volume 17 Issue 5 Pages 226-231
    Published: May 15, 1968
    Released on J-STAGE: November 25, 2009
    JOURNAL FREE ACCESS
    Download PDF (950K)
feedback
Top