The issue of robust multi-input multi-output (MIMO) radar waveform design is investigated in the presence of imperfect clutter prior knowledge to improve the worst-case detection performance of space-time adaptive processing (STAP). Robust design is needed because waveform design is often sensitive to uncertainties in the initial parameter estimates. Following the min-max approach, a robust waveform covariance matrix (WCM) design is formulated in this work with the criterion of maximization of the worst-case output signal-interference-noise-ratio (SINR) under the constraint of the initial parameter estimation errors to ease this sensitivity systematically and thus improve the robustness of the detection performance to the uncertainties in the initial parameter estimates. To tackle the resultant complicated and nonlinear robust waveform optimization issue, a new diagonal loading (DL) based iterative approach is developed, in which the inner and outer optimization problems can be relaxed to convex problems by using DL method, and hence both of them can be solved very effectively. As compared to the non-robust method and uncorrelated waveforms, numerical simulations show that the proposed method can improve the robustness of the detection performance of STAP.

In recent years, since Turbo and LDPC codes are very close to the Shannon limit, a great deal of attention has been placed on the capacity of AWGN and fading channels with arbitrary inputs. However, no closed-form solution has been developed due to the complicated Gaussian integrations. In this paper, we investigate the capacity of AWGN and fading channels with BPSK/QPSK modulation. First, a simple series representation with fast-convergence for the capacity of AWGN is developed. Further, based on the series expression, the capacity of fading channels including Rayleigh, Nakagami and Rice fading can be obtained through some special functions. Numerical results verify the accuracy and convergence speed of the proposed expressions for the capacity of AWGN and fading channels.

We describe the design and simulation of a suitable branching ratio for an optical coupler for a cable re-routing operation support system with no service interruption, and report our experimental results. We also show the risk analysis, and report that the branching ratio was 0.47 where the probability was 99.7% that the maximum acceptable cable loss of a detour line was more than that of the current line.

The elastic optical network (EON) is a promising new optical technology that uses spectrum resources much more efficiently than does traditional wavelength division multiplexing (WDM). This paper focuses on the routing, modulation level, spectrum and transceiver allocation (RMSTA) problems of the EON. In contrast to previous works that consider only the routing and spectrum allocation (RSA) or routing, modulation level and spectrum allocation (RMSA) problems, we additionally consider the transceiver allocation problem. Because transceivers can be used to regenerate signals (by connecting two transceivers back-to-back) along a transmission path, different regeneration sites on a transmission path result in different spectrum and transceiver usage. Thus, the RMSTA problem is both more complex and more challenging than are the RSA and RMSA problems. To address this problem, we first propose an integer linear programming (ILP) model whose objective is to optimize the balance between spectrum usage and transceiver usage by tuning a weighting coefficient to minimize the cost of network operations. Then, we propose a novel virtual network-based heuristic algorithm to solve the problem and present the results of experiments on representative network topologies. The results verify that, compared to previous works, the proposed algorithm can significantly reduce both resource consumption and time complexity.

Predicting the service performance of Internet applications is important in service selection, especially for video services. In order to design a predictor for forecasting video service performance in third-party application, two famous service providers in China, Iqiyi and Letv, are monitored and analyzed. The study highlights that the measured performance in the observation period is time-series data, and it has strong autocorrelation, which means it is predictable. In order to combine the temporal information and map the measured data to a proper feature space, the authors propose a predictor based on a Conditional Restricted Boltzmann Machine (CRBM), which can capture the potential temporal relationship of the historical information. Meanwhile, the measured data of different sources are combined to enhance the training process, which can enlarge the training size and avoid the over-fit problem. Experiments show that combining the measured results from different resolutions for a video can raise prediction performance, and the CRBM algorithm shows better prediction ability and more stable performance than the baseline algorithms.

Orthogonal frequency division multiplexing (OFDM) promises to provide the necessary boost in the core networks' capacity along with the required flexibility in order to cope with the Internet's growing heterogeneous traffic. At the same time, wavelength division multiplexing (WDM) technology remains a cost-effective and reliable solution especially for long-haul transmission. Due to the higher implementation cost of optical OFDM transmission technology, it is expected that OFDM-based bandwidth variable transponders (BVT) will co-exist with conventional WDM ones. In this paper, we provide an integer linear programming (ILP) formulation that minimizes the cost and power consumption of such hybrid architecture and then a comparison is made with a pure OFDM-based elastic optical network (EON) and a mixed line rate (MLR) WDM optical network in order to evaluate their cost and energy efficiency.

This paper aims to establish expressions for IEEE 802.11 string-topology multi-hop networks with transmission control protocol (TCP) traffic flow. The relationship between the throughput and transport-layer function in string-topology multi-hop network is investigated. From the investigations, we obtain an analysis policy that the TCP throughput under the TCP functions is obtained by deriving the throughput of the network with simplified into two asymmetric user datagram protocol flows. To express the asymmetry, analytical expressions in medium access control-, network-, and transport layers are obtained based on the airtime expression. The expressions of the network layer and those of transport layer are linked using the “delayed ACK constraint,” which is a new concept for TCP analysis. The analytical predictions agree well with the simulation results, which prove the validity of the obtained analytical expressions and the analysis policy in this paper.

The Localization of distributed sources has attracted significant interest recently. There mainly are two types of localization methods which are able to estimate distributed source positions: two-step methods and direct localization methods. Unfortunately, both fail to exploit the location information and so suffer a loss in localization accuracy. By utilizing the information not used in the above, a direct localization method of multiple distributed sources is proposed in this paper that offers improved location accuracy. We construct a direct localization model of multiple distributed sources and develop a direct localization estimator with the theory of multiple signal classification. The distributed source positions are estimated via a three-dimensional grid search. We also provide Cramer-Rao Bound, computational complexity analysis and Monte Carlo simulations. The simulations demonstrate that the proposed method outperforms the localization methods above in terms of accuracy and resolution.

In this paper, a simple pattern reconfigurable antenna with broadband circular polarization is proposed. The proposed antenna consists of four rectangular loops, a feeding network and four reflectors. Circular polarization is achieved by cutting two slots on opposite sides of the loops. By controlling the states of the four PIN diodes present in the feeding network, the proposed antenna can achieve four different pattern modes at the same frequency. Experiments show that the antenna has a bandwidth of 47.6% covering 1.73-2.81GHz for reflection coefficient (|S11|)<-10dB and a bandwidth of 55% covering 1.62-2.85GHz for axial ratio <3dB. The average gain is 8.5dBi and the radiation patterns are stable.

Channel capacity is a useful numerical index not only for grasping the upper limit of the transmission bit rate but also for comparing the abilities of various digital transmission schemes commonly used in radio-wave propagation environments because the channel capacity does not depend on specific communication methods such as modulation/demodulation schemes or error correction schemes. In this paper, modeling of the noncoherent capacity in a highly underspread WSSUS channel is investigated using a new approach. Unlike the conventional method, namely, the information theoretic method, a very straightforward formula can be obtained in a statistical manner. Although the modeling in the present study is carried out using a somewhat less rigorous approach, the result obtained is useful for roughly understanding the channel capacity in doubly selective fading environments. We clarify that the radio wave propagation parameter of the spread factor, which is the product of the Doppler spread and the delay spread, can be related quantitatively to the effective maximum signal-to-interference ratio by a simple formula. Using this model, the physical limit of wireless digital transmission is discussed from a radio wave propagation perspective.

Based on imperfect channel state information (CSI), the energy efficiency (EE) of downlink distributed antenna systems (DASs) with multiple receive antennas is investigated assuming composite Rayleigh fading channels. A new EE is introduced which is defined as the ratio of the average transmission rate to the total consumed power. According to this definition, an optimal power allocation (PA) scheme is developed for maximizing EE in a DAS subject to the maximum transmit power constraint. It is shown that a PA solution for the constrained EE optimization does exist and is unique. A Newton method based practical iterative algorithm is presented to solve PA. To avoid the iterative calculation, a suboptimal PA scheme is derived by means of the Lambert function, which yields a closed-form PA. The developed schemes include the ones under perfect CSI as special cases, and only need the statistical CSI. Thus, they have low overhead and good robustness. Moreover, the theoretical EE under imperfect CSI is derived for performance evaluation, and the resulting closed-form EE expression is obtained. Simulation results indicate that the theoretical EE can match the corresponding simulated value well, and the developed suboptimal scheme has performance close to optimal one, but with lower complexity.

In this paper, we provide a novel solution to mitigate pilot contamination in massive MIMO technology. In the proposed approach, we consider seven copilot cells of the first layer of interfering cells of a cellular network. We derive and formulate the worst-case signal-to-interference power ratio (SIR) of a typical user in both downlink and uplink of a pilot contaminated cell. Based on the formulated SIR and other considerations of the system, the total pilot sequence length, the reliability of channel estimation within the cell, the spectral and energy efficiencies are derived and formulated in downlink. The user's transmit power and the achievable sum rate are also derived and formulated in uplink. Our results show that when the cell size is reduced the pilot contamination is significantly mitigated and hence the system performance is improved.

In wireless communication systems, OFDM technology is a communication method that can yield high data rates. However, OFDM systems suffer high PAPR values due to the use of many of subcarriers. The SLM and the PTS technique were proposed to solve the PAPR problem in OFDM systems. However, these approaches have the disadvantage of having high complexity. This paper proposes a method which has lower complexity than the conventional PTS method but has less performance degradation.

Our previous work proposed a semi-blind single antenna interference cancellation scheme to cope with severe inter-cell interference in heterogeneous networks. This paper extends the scheme to allow multiple-receive-antenna implementation. It does not require knowledge of the training sequences of interfering signals and can cancel multiple interfering signals irrespective of the number of receive antennas. The proposed scheme applies an enhanced version of the quantized channel approach to suboptimal joint channel estimation and signal detection (JCESD) during the training period in order to blindly estimate channels of the interfering signals, while reducing the computational complexity of optimum JCESD drastically. Different from the previous work, the proposed scheme applies the quantized channel generation and local search at each individual receive antenna so as to estimate transmitted symbol matrices during the training period. Then, joint estimation is newly introduced in order to estimate a channel matrix from the estimated symbol matrices, which operates in the same manner as the expectation maximization (EM) algorithm and considers signals received at all receive antennas. Using the estimated channels, the proposed scheme performs multiuser detection (MUD) during the data period under the maximum likelihood (ML) criterion in order to cancel the interference. Computer simulations with two receive antennas under two-interfering-stream conditions show that the proposed scheme outperforms interference rejection combining (IRC) with perfect channel state information (CSI) and MUD with channels estimated by a conventional scheme based on the generalized Viterbi algorithm, and can achieve almost the same average bit error rate (BER) performance as MUD with channels estimated from sufficiently long training sequences of both the desired stream(s) and the interfering streams, while reducing the computational complexity significantly compared with full search involving all interfering signal candidates during the training period.

We consider device-to-device (D2D) direct communication underlying cellular networks where the D2D link reuses the frequency resources of the cellular downlink. In this paper, we propose a linear precoder design scheme for a base station (BS) and D2D transmitter using the weighted sum-rate of the cellular downlink and D2D link as a cost function. Because the weighted sum-rate maximization problem is not convex on the precoding matrices of BS and D2D transmitters, an equivalent mean-squared error (MSE) minimization problem which is convex on the precoding matrices is proposed by introducing auxiliary matrices. We show that the two optimization problems have the same optimal solution for the precoding matrices. Then, an iterative algorithm for solving the equivalent MSE minimization problem is presented. Through a computer simulation, we show that the proposed scheme offers better weighted sum-rate performance that a conventional scheme.

Public safety networks need to more effectively meet the increasing demands for images or videos to be shared among first responders and incident commanders. Long term evolution (LTE) networks are considered to be candidates to achieve such broadband services. Capital expenditures in deploying base stations need to be decreased to introduce LTE for public safety. However, out-of-coverage areas tend to occur in cell edge areas or inside buildings because the cell areas of base stations for public safety networks are larger than those for commercial networks. The 3rd Generation Partnership Program (3GPP) in Release 13 has investigated device-to-device (D2D) based relay communication as a means to fill out-of-coverage areas in public safety LTE (PS-LTE). This paper proposes a relay selection scheme based on effective path throughput from an out-of-coverage terminal to a base station via an in-coverage relay terminal, which enables the optimal relay terminal to be selected. System level simulation results assuming on radii of 20km or less revealed that the proposed scheme could provide better user ratios that satisfied the throughput requirements for video transmission than the scheme standardized in 3GPP. Additionally, an evaluation that replicates actual group of fire-fighters indicated that the proposed scheme enabled 90% of out-of-coverage users to achieve the required throughput, i.e., 1.0Mbps, to transmit video images.

A novel Doppler spread estimation scheme is proposed for an orthogonal frequency division multiplexing (OFDM) system with a Rayleigh fading channel. The proposal develops a composite power spectral density (PSD) function by averaging the multiple PSD functions computed with multiple sets of the channel frequency response (CFR) coefficients. The Doppler spread is estimated by finding the maximum location of the composite PSD quantities larger than a threshold value given by a fixed fraction of the maximum composite PSD quantity. It is shown by simulation that the proposed scheme performs better than three conventional Doppler spread estimation schemes not only in isotropic scattering environments, but also in nonisotropic scattering environments. Moreover, the proposed scheme is shown to perform well in some Rician channel environments if the Rician K-factor is small.

Our goal is to use a single passive moving sensor to determine the locations of multiple radio stations. The conventional method uses only direction-of-arrival (DOA) measurements, and its performance is poor when emitters are located closely in the lateral direction, even if they are not close in the range direction, or in the far field from the moving sensor, resulting in similar DOAs for several emitters. This paper proposes a new method that uses the power of the received signals as well as DOA. The received signal power is a function of the inverse of the squared distance between an emitter and the moving sensor. This has the advantage of providing additional information in the range direction; therefore, it can be used for data association as additional information when emitter ranges are different from each other. Simulations showed that the success rate of the conventional method is 73%, whereas that of the proposed method is 97%, an overall 24-percentage-point improvement. The localization error of the proposed method is also reduced to half that of the conventional method. We further investigated its performance with different emitter and sensor configurations. In all cases, the proposed method proved superior to the conventional method.