軽金属
Online ISSN : 1880-8018
Print ISSN : 0451-5994
ISSN-L : 0451-5994
74 巻, 3 号
選択された号の論文の2件中1~2を表示しています
研究論文
  • 秀嶋 保利, 前田 郁也, 福田 忠生, 尾崎 公一
    2024 年 74 巻 3 号 p. 141-146
    発行日: 2024/03/15
    公開日: 2024/04/15
    ジャーナル フリー

    AZ91D magnesium alloy chips were coated with SiC powder using a binder, and injection molding was attempted using SiC powder coated magnesium chips as raw material. The metallurgical structure of the injection molded products showed uniform dispersion of SiC particles in the matrix, and there were no significant defects such as voids at the SiC particle-matrix interface. The hardness and 0.2% proof stress of the injection molded products tended to improve with increasing SiC content, while the elongation decreased with increasing SiC content. The Young's modulus of the injection molded products improved with increasing SiC content. It was confirmed that the specific bending rigidity of the injection molded products also improves due to the significant increase in the Young's modulus, although the addition of SiC leads to an increase in density.

  • 城 敦士, 加藤 正明, 山内 啓
    2024 年 74 巻 3 号 p. 147-152
    発行日: 2024/03/15
    公開日: 2024/04/15
    ジャーナル フリー

    Cube specimens of AC4B aluminum alloy, Al-1%Mg, and Al-3%Mg were oxidized in air at 773 K for up to 25 h to investigate the influence of heat treatment time and Mg concentration. The original specimens and oxidation products were characterized by X-ray diffractometry, scanning electron microscopy, and X-ray photoelectron spectroscopy. SEM observation showed that the oxide scale grew thick and the surface of the oxide scale consisted of granular grain. Simultaneously, the tone color of the specimens became darker. The XRD and XPS analysis indicated that oxide scales mainly consist of MgO and MgAl2O4, and the top surface was covered with MgO. In addition, the ratio of MgAl2O4 on the surface of oxide scales tended to increase with heat treatment time. The XPS depth profile of Al-3%Mg alloy showed that oxide scale grew up to the thickness of 6μm. The thermodynamic calculations suggested that the most stable compound on the surface of specimens is MgAl2O4 and then the kinetic factor is strongly influenced by the surface oxidation of Mg-containing Al alloys.

feedback
Top